Overview
The Crown Automotive drivetrain mount kit, part number 8128488K, is a set of engine, transmission and stabilizer mounting parts for the 4.2L 258 6 cylinder engine. The kit contains two engine mounts, a transmission mount, a transmission stabilizer bolt and two engine stabilizer bushings.
Crown Automotive has supplied replacement parts for Jeep vehicles for over 50 years and offers more than 8,000 part numbers, including discontinued items. The kit fits CJ5, CJ7, J10, J20 and Scrambler models.
Key features
- Two engine mounts and one transmission mount in one kit
- Transmission stabilizer bolt included
- Two engine stabilizer bushings included
- Built for the 4.2L 258 6 cylinder engine
- Direct fit listing for the Jeep models shown in the fitment section
Signs worn mounts need replacing
Engine and transmission mounts carry the weight of the drivetrain and absorb the vibration that comes with it. Over time the rubber can crack, separate from its metal plate or harden, which lets the drivetrain move more than it should. Excess movement often shows up as a clunk when shifting or accelerating.
Look for sagging engine position, a shifter that travels farther than usual, or extra vibration at idle. Stabilizer bushings and the transmission stabilizer bolt control side-to-side movement, so worn bushings can cause the same symptoms. Inspect them with the engine supported before removing any mount.
Replace mounts in matched sets where possible so that load is shared evenly. Check the frame and crossmember for cracks or corrosion around the mount points, since a sound mount on a weak bracket will wear out quickly.
- Cracked or separated mount rubber
- Clunks when shifting or accelerating
- Excess engine movement at idle
- Sagging engine or transmission position
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 8128488K |
| UPC | 848399078091 |
| Category | Drivetrain mount kit |
| Engine | 4.2L 258 6 cylinder |
| Kit contents | 2 engine mounts, 1 transmission mount, 1 transmission stabilizer bolt, 2 engine stabilizer bushings |
| Fitment type | Direct fit |
Vehicle fitment
The listed fitment is 1976-1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), 1976-1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade), 1974-1987 Jeep J10 (Base), 1974 and 1976 Jeep J20 (Base), and 1981-1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR).
Wrangler, Cherokee and other Jeep generations are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes the transmission stabilizer bolt and engine stabilizer bushings, so those parts come with the mounts. Support the engine and disconnect the battery before replacing mounts.









