Overview
The Crown Automotive 5149182AB is an air temperature sensor for 3.0L diesel engines. Listed fitment covers the 2011–2018 Dodge Durango and Dodge Journey, the 2014–2018 Jeep Cherokee, the 2011–2018 Jeep Grand Cherokee (WK) and the 2012–2018 Jeep Wrangler (JK).
Confirm the engine is the 3.0L diesel before ordering, since several models share this fitment range.
Key features
- Air temperature sensor for 3.0L diesel engines
- Listed across Dodge Durango and Journey and multiple Jeep models
- Model years listed run from 2011 to 2018
- Crown Automotive part number 5149182AB
Sensor role and wear signs
An air temperature sensor reports the temperature of the air entering the engine to the vehicle’s control module. That reading feeds fuel and timing calculations, so a sensor that reads incorrectly can cause rough idle, hesitation or weaker fuel economy. Symptoms often appear before any warning light, which makes a quick check worthwhile when the engine runs differently than usual.
When this 3.0L diesel sensor is replaced, inspect the connector pins for corrosion and make sure the wiring clip is intact. Engine bay heat and moisture can soften plastic housings over time, so seat the plug fully and keep water away from it after installation. If other intake work is planned, such as an air filter change, it is a sensible time to inspect the sensor too.
- Look for cracks or melting on the sensor housing
- Check the connector seal before reconnecting
- Clear stored fault codes after the replacement
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5149182AB |
| UPC | 849603005827 |
| Engine | 3.0L diesel |
| Sensor type | Air temperature |
Vehicle fitment
It fits 2011–2018 Dodge Durango (multiple trims), 2011–2018 Dodge Journey, 2014–2018 Jeep Cherokee, 2011–2018 Jeep Grand Cherokee (WK and later), and 2012–2018 Jeep Wrangler (JK).
Models from 2010 and earlier, and Wrangler JL and later models, aren’t on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Compare the sensor’s position and connector with the old sensor before installing.
What’s included
The package contains the sensor only, with no hardware or connectors. Check the package contents against your installation before starting.









