Overview
The Crown Automotive accelerator throttle cable, part number 52104284AB, is a replacement cable that links the accelerator pedal to the throttle. The company describes its catalog as replacement parts for Jeep vehicles, and this cable is marked Direct Fit.
Confirm your vehicle’s year, model and trim against the cable before installing it.
Routing and adjustment basics
Accelerator cables work by sliding an inner wire inside a sheath, so smooth movement depends on a clean path with gentle bends. Where the cable passes near the intake, brake lines or wiring, a small change in position can add friction and make the pedal feel heavy. Routing the sheath so it lies free of contact points is often the simplest way to keep throttle response consistent.
Adjustment matters as much as the part itself. After the cable is connected, cycle the pedal several times with the engine off and watch the throttle plate return fully against its stop. A cable that is slightly too long can keep the throttle from closing, while one that is too short can hold the pedal partly down.
- Keep the sheath clear of heat sources
- Check the inner wire for fraying before reuse
- Confirm the throttle closes with the pedal released
- Lubricate pivot points during routine service
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52104284AB |
| UPC | 848399086423 |
| Part type | Accelerator throttle cable |
| Fitment | Direct Fit |
Vehicle fitment
The cable is marked Direct Fit. Confirm its application to your vehicle before installing it, comparing the length and end fittings with your original cable.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Route the cable so it does not bind on the intake or linkage, and adjust it so the throttle returns fully to idle. A sticking cable can hold the throttle partly open.
What’s included
Check the package contents against your installation before starting.









