Overview
The Crown Automotive J3193369 is an accelerator pedal return spring, also called a throttle return spring, that fits 1981 to 1996 Jeep applications. It returns the accelerator pedal or throttle to idle when you lift your foot.
Crown Automotive has made replacement parts for Jeep vehicles for over 50 years and carries more than 8,000 part numbers, including many factory-discontinued items. This spring is a direct-fit part.
Key features
- Accelerator pedal return spring (throttle return spring)
- Fits 1981 to 1996 Jeep applications
- Direct fit
- Replacement part from Crown Automotive
Throttle return checks
The accelerator return spring pulls the pedal and throttle back to idle, so a weak or broken spring can leave the engine idling high or slow to drop back. Before a drive, press the pedal by hand with the engine off and watch the throttle close fully. Any sticking, binding or slow return points to the spring, the pedal pivot or the cable linkage.
Springs fatigue with age and heat, and a spring that has lost tension may look fine while still returning too slowly. Check the pedal pivot and linkage at the same time, since worn bushings or dry pivots can mimic a bad spring. Keep the throttle area free of debris so nothing hangs up the return path.
- Inspect the spring for stretching or coil damage
- Lubricate pedal pivots lightly after cleaning
- Replace the spring when it no longer returns the pedal fully
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3193369 |
| UPC | 848399058857 |
| Product type | Accelerator pedal return spring |
| Category | Performance Parts > Throttle Return Spring |
| Listed years | 1981 to 1996 Jeep applications |
| Fit type | Direct fit |
Vehicle fitment
The spring fits 1981 to 1996 Jeep applications; confirm fit for your vehicle’s model and engine before ordering.
Compare the spring with your original before installing, since the right match depends on your vehicle’s model and trim.
Installation notes
The accelerator return spring controls throttle closing, so make sure the pedal and throttle return freely before driving. Have a professional install it if the linkage is unfamiliar.
Test the pedal at idle with the engine off, and check that the throttle fully closes. Re-check the linkage after the first miles of driving, and do not drive if the pedal sticks.
What’s included
- Accelerator pedal return spring
Not included: linkage, cable or any related hardware.









