Overview
The Bushwacker 31009-11 is a cut-out fender flare pair for the Toyota Pickup or 4Runner. Each set is designed for the specific vehicle to maximize off-road wheel travel and keep adequate tire coverage, and this pair adds up to 2.25 in. of coverage against debris. Confirm the model years before ordering, since the cut lines depend on the model.
Cut-out flares are made for extreme off-road use. Installation requires cutting body sheet metal, which removes the limit on articulation for oversized tires. The OEM matte black finish is UV protected and paints easily, and the Dura-Flex 2000 material is thick, warp-resistant and flexible in severe conditions.
Key features
- Adds up to 2.25 in. of tire coverage against debris
- Sheet metal removal maximizes wheel articulation
- Rivet installation for a tough, secure fit
- OEM matte black finish that paints easily
- Dura-Flex 2000 material, 100% UV protected
- Made in the USA, with a Limited Lifetime Warranty
Rivets and body work
Rivet-mounted flares rely on drilled holes and the sheet metal around them to hold the fender shape. Drilling and riveting are done after the cut, so the bare edges and new holes should be sealed to slow corrosion.
Good prep makes a clean install. Use a sharp blade for straight cut lines, clean up burrs, and set rivets evenly so the flare sits flush. A small bead of sealant under the flare edge can keep water and mud from getting behind it.
Off-road trips put stress on mounts, so recheck the rivets and inspect the flare edges after rough use. Cracks around the holes or a flare that shifts on its mount mean the fastening needs attention.
- Seal bare metal and drilled holes
- Deburr cut edges before mounting
- Check rivets and mounts after off-road trips
- Inspect flare edges for cracks
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 31009-11 |
| UPC | 90689103291 |
| Vehicle | Toyota Pickup or 4Runner (model years not stated) |
| Position | Front, per the product name |
| Sold as | Pair |
| Other part numbers | 31010-11 and 31022-11, listed in the bullets |
| Tire coverage | Up to 2.25 in. |
| Style | Cut-out, sheet metal removed |
| Finish | OEM matte black, smooth, paintable |
| Material | Dura-Flex 2000, 100% UV protected |
| Installation | Rivets, with sheet metal cutting |
| Warranty | Limited Lifetime |
| Made in | USA |
Vehicle fitment
The flares are made for the Toyota Pickup and 4Runner. Before buying, make sure your vehicle’s year and model fit the cut lines.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The flares must be fitted by cutting body sheet metal and securing them with rivets. Bushwacker points to the installation guide for the specific model, so read it before cutting. The bullets list 31010-11 and 31022-11 as rear pair part numbers, so confirm the position you need.
What’s included
A pair of cut-out fender flares. Rear pair part numbers 31010-11 and 31022-11 are listed separately.









