Overview
The Bushwacker Cut-Out Style rear fender flare pair, part 20002-07, is made for the Ford Bronco. This Cut-Out design is shaped around the Bronco to open up off-road wheel travel while keeping tire coverage. The pair adds 1.5 inches of width and tire coverage at the rear and fits the 1966 to 1977 Ford Bronco and the 1975 to 1977 Bronco Sport.
Full articulation and coverage for oversized tires depend on cutting away the body sheet metal on this flare. The design gives a smoother appearance and greater strength, and the pair is made from thick, warp-proof Dura-Flex 2000 TPO. UV protection keeps the finish from chalking, and the matte black finish can be left as is or custom painted.
Key features
- Individually designed for the Ford Bronco
- 1.5 inches of width and tire coverage at the rear
- Sheet metal removal maximizes wheel articulation
- Stainless steel hardware for an easier bolt-on installation
- 100% UV protected Dura-Flex 2000 TPO that guards against chalking
- OEM matte black finish that can be custom painted
Rear articulation and tire rub
The rear tire moves up into the opening during suspension compression, so rear cut-out flares should be checked at full compression as well as at ride height. Rubbing typically starts at the flare’s rear edge or at the lower corner nearest the wheel. Lift height, tire width and wheel offset all change the tire’s position, so test with the tires you plan to run.
Rear flares also protect the body from thrown rocks and mud. Clean out the gap between the flare and body regularly, since debris trapped there can scratch paint and hold moisture against the metal. Check welds and body-side fasteners after each season of off-road use.
- Check clearance at full compression
- Clear debris from the gap behind the flare
- Inspect body-side fasteners after off-road use
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 20002-07 |
| UPC | 90689100092 |
| Position | Rear |
| Quantity | Pair |
| Width and coverage | 1.5 inches |
| Material | Dura-Flex 2000 TPO |
| Finish | OEM matte black, paintable |
| Front pair part number | 20001-07 |
| Extra large rear pair part number | 20005-07 |
Vehicle fitment
It fits the 1966 to 1977 Ford Bronco, including the Base, Custom, Northland, Ranger, Roadster and Wagon models in those years, and the 1975 to 1977 Bronco Sport.
The list covers the first-generation Bronco years only, so the 1992 to 1996 Bronco and later models are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rear pair requires cutting body sheet metal, so it is not a bolt-on-only install. Follow the Bronco installation guide before cutting, and check the rear clearance at full suspension travel once the pair is on.
What’s included
Two rear Cut-Out flares. The front pair is part 20001-07, and the extra large Cut-Out rear pair is part 20005-07.









