Overview
The Bushwacker Cut-Out Style fender flare set, part 10910-07, is a front and rear set of four flares for the Jeep CJ series. Each set is designed for the vehicle to maximize off-road wheel travel while keeping adequate tire coverage. The set provides 6 inches of tire coverage for oversized tires.
The flares are made from thick, warp-proof Dura-Flex 2000 TPO. The matte black finish looks good as is, or it can be custom painted. The set comes with stainless steel hardware and uses a bold pocket style. The front and rear wheel openings are covered by one kit of four, and the UV protection guards against chalking.
Key features
- Cut-Out design individually made for the Jeep CJ series
- 6 inches of tire coverage for oversized tires
- Complete with stainless steel hardware
- Designed for extreme tire and wheel coverage
- UV protected Dura-Flex 2000 TPO that guards against chalking
- OEM matte black finish that can be custom painted
Cutting plan for older bodies
Cut-out CJ flares depend on sheet metal work, and older CJ bodies can have rust, filler panels and fuel system parts close to the wheel openings. A careful look before cutting prevents surprises once the metal is open.
Start by measuring the clearance between the tire and the body at full lock and full compression. Mark the cut line in small sections, test the fit with the flares held in place, and cut only what is needed for the tire to move freely.
Once cutting is finished, deburr each edge and treat the bare metal right away. Stainless hardware resists corrosion, so use it for every fastener at the flare, and check the bolts after the first rough drives to keep the install tight.
- Measure clearance at full lock and compression
- Check the side gas tank filler before cutting
- Cut in small steps and test often
- Prime and seal exposed metal
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 10910-07 |
| UPC | 90689105967 |
| Position | Front and rear |
| Quantity | Set of 4 |
| Width and coverage | 6 inches |
| Material | Dura-Flex 2000 TPO |
| Finish | OEM matte black, paintable |
| Hardware | Stainless steel |
| Fitment type | Direct fit |
Vehicle fitment
Confirm fit for your CJ model and year before ordering, because the set covers the CJ series rather than one year range. Some CJ5, CJ6 and CJ7 models from 1956 to 1960 and 1966 to 1986 may have a side gas tank filler that interferes with fit.
Some CJ5, CJ6 and CJ7 models from 1956 to 1960 and 1966 to 1986 may have a side gas tank filler that interferes with fitment, so check that filler first. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cut-Out flares require cutting body sheet metal to reach maximum articulation and coverage, so plan for cutting rather than a bolt-on-only install. Check the CJ side gas tank filler and the installation guide for your model before cutting.
What’s included
A set of four Cut-Out flares, front and rear, with stainless steel hardware.
















