Overview
The Bushwacker 40003-11 is a pair of cut-out front fender flares for Chevrolet and GMC trucks. Bushwacker designs each set for a specific truck to maximize off-road wheel travel and keep adequate tire coverage. Because the flare is cut out to free the wheel, the installation requires cutting body sheet metal, which Bushwacker says is needed for maximum articulation and coverage with oversized tires.
The flares are made from thick, warp-proof Dura-Flex 2000 material with UV protection, and they resist chalking. The finish is an OEM matte black designed to be painted. The coverage width is 2 inches, and the flares are sold as a pair. The bolt-on hardware is stainless steel.
Key features
- Cut-out design removes sheet metal for maximum wheel articulation
- Individually designed for the listed truck models
- Thick, warp-proof Dura-Flex 2000 material
- Stainless steel bolt-on hardware
- OEM matte black finish, paintable
- Made in the USA with a limited lifetime warranty
Planning the cut before fitting
A cut-out flare changes the body, so the planning stage matters more than the bolt-on step. Before marking any line, inspect the fender and inner panels for rust, prior repairs and brackets that may be hidden behind the sheet metal. Check the wheel travel and the steering arc with the old fender in place so the cut does not remove more than needed.
The cut edge needs finishing. Deburr it, treat the bare metal with a rust-inhibiting primer and seal the joint where the flare meets the body. Paint can then be applied to match the truck. Keep the old sheet metal pieces until the fit is confirmed, in case a trim line needs to be reworked.
- Inspect for rust before marking
- Confirm steering clearance before cutting
- Deburr and prime the cut edge
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 40003-11 |
| Position | Front |
| Quantity | Pair |
| Width and coverage | 2 inches |
| Installation | Requires cutting body sheet metal |
| Hardware | Stainless steel |
| Material | Dura-Flex 2000 |
| Warranty | Limited lifetime |
| UPC | 90689103345 |
Vehicle fitment
Bushwacker lists these flares for the 1973–1980 Chevrolet C10, C20 and C30 and K10, K20 and K30 pickups and their Suburban versions, the 1975–1980 Chevrolet K5 Blazer, the 1973–1980 GMC Jimmy, and the GMC C15, C25, C35, K15, K25 and K35 pickups from 1973 to 1980.
Vehicles from other model years, and the 1981 and later C/K trucks, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cut-out flares require cutting body sheet metal, so review the installation steps for your specific model before starting. The bolt-on installation uses stainless steel hardware, and the flares can be painted after installation.
What’s included
One pair of front cut-out flares. The rear pair is part 40004-11.









