Overview
The ARB Auxiliary Lighting Loom, part 3500440, is a wiring loom used with ARB fog lamp kit 6821201. It is universal fit and is needed only on vehicles without original equipment fog lights.
On vehicles with factory fog lights, ARB part 6821201 plugs straight into the factory wiring harness and runs from the existing fog light switch on the dash. Where there are no factory fog lights and no dash switch is mounted yet, this loom supplies the wiring harness and switches needed to operate the ARB fog lamps.
Key features
- Wiring harness for ARB fog lamp kit 6821201
- Switches included for dash operation
- Needed only where original equipment fog lights are absent
- Not required on vehicles that already have factory fog lights
- Universal fitment, no vehicle named
Fog lamp wiring basics
Fog lamps draw enough current that the feed should be fused and switched through a relay rather than run directly from a dash switch. Route the harness away from hot exhaust parts, sharp edges and moving suspension. Secure the loom at regular intervals so it does not rub or pull at the connectors.
Good electrical connections matter as much as the wiring route. Use sealed connectors where the harness passes through the body or into a damp area, and make sure the earth point is clean and tight. Test the lamps with the engine running before closing up trim, since a fault is easier to trace while everything is still exposed.
- Fuse and relay the fog lamp feed
- Route away from heat and moving parts
- Use sealed connectors in damp areas
- Test before refitting trim
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | 3500440 |
| UPC | 9332018000019 |
| Used with | ARB fog lamp kit 6821201 |
| Includes | Wiring harness and switches |
| Fitment | Universal fit |
Vehicle fitment
No year, make or model applies because the loom is universal fit. Whether you need it depends on whether your vehicle already has original equipment fog lights and a dash switch.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fit this loom only where the vehicle has no factory fog lights; if it does, use ARB part 6821201 on the factory harness instead. Wiring should be done by someone comfortable with automotive electrics, with the fog lamp feed protected by a fuse and checked against local rules for auxiliary lights.
What’s included
The wiring harness and switches needed to operate ARB fog lamps on a vehicle without original equipment fog lights.
Not included: The fog lamps themselves. ARB fog lamp kit 6821201 is a separate part.








