Overview
The AirLift SmartAir II (part 25490) is an automatic self leveling system for leaf-sprung vehicles. A 100 PSI, 12V single-path compressor inflates or deflates the air springs, and a height sensor decides which way to adjust.
The height sensor is non-contact and magnetic. Because it can tell whether the air springs need to be inflated or deflated, the system holds the vehicle level without manual adjustment.
The kit is built around one compressor and one sensor, so the system works on a single air path. AirLift describes its components as OEM-grade and its materials as weather-resistant, and the kit is covered by a two-year warranty.
Key features
- 100 PSI compressor on a 12V supply
- Single-path system
- Non-contact magnetic height sensor
- Pre-assembled wire harness with a height sensor ECU
- Weather-resistant materials and OEM-grade components
- Two-year warranty
Wiring and mounting considerations
A self leveling system is only as dependable as its air springs and fittings, so inspect those parts before and after installation. Look for cracks, abrasion from rubbing and any seepage at connections. Air leaks force the compressor to run longer and can leave the vehicle sitting low overnight, which makes a regular leak check worthwhile. Keep a simple record of pressure readings after the first few weeks so changes are easy to spot.
The compressor and sensor need a secure mounting location away from water splash and direct heat, and the wire harness should be routed clear of moving parts and sharp edges. Use the included hardware, add drip loops where wiring drops down, and keep the height sensor linkage free of binding. A clean, well-supported install makes later troubleshooting much simpler.
- Check fittings for seepage after the first week
- Keep wiring clear of exhaust and suspension travel
- Recheck the sensor link after rough trail use
Specifications
| Brand | AirLift |
|---|---|
| Part number | 25490 |
| UPC | 729199254901 |
| Compressor pressure | 100 PSI |
| Voltage | 12V |
| Path | Single path |
| Height sensor | Non-contact, magnetic |
| Warranty | Two years |
Vehicle fitment
The system is built around leaf-sprung vehicles that use air springs. Confirm your suspension uses leaf springs with air springs before ordering.
Installation notes
No air line or wiring has to pass into the cab, so the firewall does not need drilling. AirLift estimates a typical installation at 2 hours or less.
What’s included
The kit includes a pre-assembled wire harness, the height sensor ECU, the compressor and the required hardware.
Not included: the air springs that the system inflates, which are not in the kit contents.














