Overview
The Addictive Desert Designs Stealth Fighter front bumper, part ADSF111182860103, is a hammer black radius plate steel front bumper for the 2017–2020 Ford F-150 Raptor. It measures only 1/2 inch farther from the grille than the factory bumper, so it keeps a tight fit around the front of the truck.
The radius plate design matches the factory front end while adding the protection of a steel bumper. The center of the bumper has a universal light mount that takes up to 10 cube lights or a 40-inch radius LED, or any mix between those. Additional mounts for RIGID 10-inch SR LEDs sit behind the side panels.
The bumper is not winch mount compatible, and D-ring mounts are not included with it. It is steel, and it comes with light mounts included.
The side mounts are sized for RIGID 10-inch SR LED lights, while the center mount can take a 40-inch radius LED or up to 10 cube lights. That layout lets the front carry a light bar in the middle and smaller lights at the sides, all behind the same steel bumper.
Key features
- Radius plate steel design that stays close to the front of the truck
- Projects only 1/2 inch farther from the grille than the factory bumper
- Universal center light mount for up to 10 cube lights or a 40-inch radius LED
- Side mounts behind the panels for RIGID 10-inch SR LED lights
- Hammer black finish
Steel bumper upkeep off road
A steel bumper takes a lot of abuse, and its finish is the first line of defense against corrosion. After mud runs, rinse the underside and the edges, since trapped mud holds moisture against the metal. Hammer black finishes hide scratches well, but any chip that reaches bare metal should be touched up before rust can spread.
Front-end accessories change airflow and weight, so plan around them. Sensor and camera placement should be checked after the bumper is fitted, and any light wiring should be secured so it does not rub the bumper edge or the radiator area.
- Rinse mud from the bumper edges after trail use
- Touch up chips before rust starts
- Check sensor and camera placement after installation
- Secure light wiring away from the bumper edge
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | ADSF111182860103 |
| Position | Front |
| Width | Full |
| Material | Steel |
| Finish | Hammer black |
| Winch mount | Not compatible |
| Light mounts | Included, universal center mount plus side mounts for RIGID 10-inch SR LEDs |
| D-ring mounts | Not included |
| Projection from grille | About 1/2 inch farther than the factory bumper |
| Installation type | Direct fit |
Vehicle fitment
It is a direct fit for the 2017–2020 Ford F-150 Raptor, and the design is drawn to the Raptor’s front body.
It fits 2017–2020 Ford F-150 Raptor models only. The 2021–2022 Raptor and standard F-150 models are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
The hammer black steel front bumper with its universal center light mount and the side mounts for RIGID 10-inch SR LEDs.
Not included: D-ring mounts and shackles, LED light bars and cube lights.












