Overview
The Warn Wire Rope, part number 89213, is a 3/8 in. by 80 ft. wire rope for Warn Zeon 10 and Zeon 12 winches. It is universal fit, so it is recovery gear matched to the winch rather than to a specific vehicle.
Wire rope is the cable that spools off the winch drum during a pull. Match the rope diameter and length to your winch model before you install it.
Rope care and replacement
Wire rope is the working line of a winch, and the drum spooling pattern depends on keeping the rope tight and even. Rope that is wound loosely can dig into lower layers and cause uneven wear. Keep steady tension when spooling in, and avoid letting the rope run out in loose coils that can tangle.
Clean the rope after muddy or salty use, and inspect it before each trip for kinks, broken wires, flattened sections and crushed areas near the drum. Replace the rope when damage concentrates in one spot, since a weak section can fail under load. Lubricate with a product suited to wire rope and your winch. Check the hook or thimble ends for distortion and wear every time you inspect the rope.
Specifications
| Brand | Warn |
|---|---|
| Part number | 89213 |
| UPC | 12748892137 |
| Diameter | 3/8 in. |
| Length | 80 ft. |
| Winch models | Zeon 10, Zeon 12 |
Vehicle fitment
Fit is by winch model, not by vehicle. It is for Zeon 10 and Zeon 12 winches and is universal fit, with no make, model or years attached.
What’s included
End fittings and other hardware are unknown. Check the rope and any fittings against your winch’s requirements before installing.









