Overview
The Warn Replacement Motor Shaft Coupling, part number 16027, is a replacement coupling listed under Warn industrial winch replacement parts. It is meant to connect to the winch motor shaft.
Confirm your winch series before ordering, since this coupling is made for industrial winches rather than truck or Jeep use.
Key features
- Replacement motor shaft coupling
- Part number 16027 and UPC 12748160274
- Listed among industrial winch replacement parts
- Matched by winch model, battery voltage and serial number
Shaft connection and alignment
A motor shaft coupling links the motor output to the drive, so it carries torque and absorbs small misalignments between the two shafts. Misalignment often shows up as vibration, noise or early wear on the coupling itself. Before fitting a new part, check that both shafts are clean, straight and free of burrs, since debris on the shaft can prevent full seating.
Motors, brakes and gearing vary across winch designs, and a coupling that fits one shaft may not suit another. Inspect the motor bearings and seals at the same time, because a worn coupling is often a sign of a larger alignment problem. Recheck the connection after the first short test run.
- Look for cracks, rounding or heat marks on the coupling
- Check the shaft for scoring at the contact area
- Confirm alignment before running the winch under load
Specifications
| Brand | Warn |
|---|---|
| Part number | 16027 |
| UPC | 12748160274 |
| Part type | Motor shaft coupling |
| Winch category | Warn industrial winch |
Vehicle fitment
This coupling is not vehicle-specific. No vehicle is named, so the fit depends on the industrial winch it goes into.
Confirm the winch model before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
On planetary gear models the serial number is on the gear end housing, so read it before ordering a motor-side part.
What’s included
It is sold as a single coupling.
Not included: The motor and gearing are not included.









