Overview
The Recon 264216WH is a unidirectional LED replacement bulb with built-in current limiting resistors. It is universal fit, so it works as a general replacement rather than a vehicle-specific part.
Some newer vehicles flag an LED turn signal as burnt out because the bulb draws so little current. A load resistor wired across the turn signal bulb imitates a filament bulb load, and it is a separate item that is not included with this bulb.
Key features
- Built-in current limiting resistors
- Very low power consumption
- Practically no heat generated
- Average life of up to 80,000 hours
- Unidirectional LED design
Turn signal flash and LED loads
LED turn signals draw much less current than the filament bulbs that a vehicle’s flasher was designed around. When the current drops below what the flasher expects, the flash rate can speed up or the dash may show a warning. This is a general effect of LED lamps rather than a fault in the bulb, and it is one reason many owners pair LED turn signals with a flasher suited to LED loads or a load resistor.
Before changing anything, check whether the front and rear signals on the same side are both LED, since mixing bulb types can confuse the flasher. Inspect the socket for corrosion and make sure the contacts grip the bulb firmly, because a loose socket causes intermittent flashing that is often blamed on the bulb. If you add a resistor, keep it secured away from heat and from wiring that could melt.
Specifications
| Brand | Recon |
|---|---|
| Part number | 264216WH |
| UPC | 810614013477 |
| Bulb type | Unidirectional LED |
| Average life expectancy | Up to 80,000 hours |
| Fitment | Universal fit |
Vehicle fitment
It is universal fit, so it is not built for one vehicle. Check the socket and turn signal setup in your vehicle before you buy.
No model years or compatible vehicles are named for this bulb.
Installation notes
Work on turn signal wiring with the battery disconnected, and check local lighting rules before changing any circuit. A load resistor is the remedy Recon describes for LED-related warnings.
What’s included
One unidirectional LED bulb, part number 264216WH, is included. Check the quantity in your order against the number of turn signals you are changing.
Not included: Load resistors, which are mentioned only as a separate item.









