Overview
The Recon 264213WH is a white unidirectional LED replacement bulb with built-in current limiting resistors. It is a universal fit bulb, and it is designed to be low power with practically no heat and an average life expectancy of up to 80,000 hours.
LED bulbs draw less current than filament bulbs, and some newer vehicles read that as a burnt-out bulb. Recon says those cars may flash the turn signals faster or light a bad bulb indicator, and it recommends its Load Resistors wired across the turn signal bulbs to simulate a filament load.
Key features
- Extremely low power consumption
- Built-in current limiting resistors
- Generates practically no heat
- Average life expectancy of up to 80,000 hours
- White color, universal fit
Turn signal flash rate
Turn signal flashers were designed around the current a filament bulb draws. When an LED bulb draws less current, the flasher may run at a different rate or the dash may show a warning. This is a common issue after changing turn signal bulbs and is not a sign that the new bulb has failed.
Solutions include a compatible electronic flasher or a load resistor wired across the signal circuit, depending on the vehicle. Test each change with the lights switched on from the outside of the vehicle, and keep the lamp housing sealed to protect the bulb from moisture.
- Test turn signals from outside the vehicle after changes
- Confirm the flasher is compatible with LED loads
- Keep the lamp housing sealed against moisture
Specifications
| Brand | Recon |
|---|---|
| Part number | 264213WH |
| UPC | 810614012067 |
| Color | White |
| Bulb type | Unidirectional LED |
| Average life expectancy | Up to 80,000 hours |
| Fitment | Universal fit |
Vehicle fitment
This bulb is a universal fit, so it is not vehicle-specific. Fit depends on whether your lamp socket accepts this bulb type.
Load resistors are a separate item that Recon mentions for vehicles that show a bad bulb warning.
Installation notes
If your vehicle reports a burnt-out turn signal after switching to LED, Recon’s stated remedy is a load resistor wired across the turn signal bulb. Disconnect the battery before working on any lighting wiring, and check local rules for lighting changes.
What’s included
One white unidirectional LED bulb under part number 264213WH.
Not included: Recon Load Resistors, which are mentioned as a separate remedy.












