Overview
The Trail Gear Bumper Mount, part number 120248-1-KIT, is a winch bumper mounting component from Trail Gear. It is a direct fit mount, and the bumper or truck it suits depends on your bumper and winch combination.
The mount is filed in the winch bumper mounting channel group, so compare its mounting points with your bumper and winch before you install it.
Winch bumper mounting basics
A winch bumper mount carries the full pulling load of the winch, so it has to sit square to the bumper and the winch plate. Before fitting, check that the bolt holes line up cleanly and that the bumper is in good condition, since a mount is only as strong as the metal it attaches to. A bent or cracked bumper can crack a mount under load.
Once installed, re-check the fasteners after the first few trail runs, because vibration can loosen bolts over time. Look for cracks around welds, deformed brackets and paint chips that signal flexing. Mounts that have taken a hard pull should be inspected before the next recovery.
- Test-fit the mount before final tightening
- Re-check fasteners after the first trail runs
- Inspect welds and brackets after heavy use
- Replace mounts that show cracks or bending
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120248-1-KIT |
| UPC | 700007372661 |
| Fitment type | Direct fit |
Vehicle fitment
This mount is direct fit, but it is not tied to a named make, model or years. Confirm the bumper and winch combinations it suits against your own vehicle before installing.
What’s included
Verify the package contents match your installation plan first. The KIT suffix indicates a kit, so the individual pieces and any hardware may need to be confirmed before you begin.









