Overview
The 140058-1-KIT is a brake backing plate eliminator kit for front Toyota solid axles. It fits the 1984-1985 Toyota 4Runner and the 1979-1985 Toyota Pickup. The kit has two spacer rings that take the place of the factory backing plates.
Trail Gear says backing plates on these axles often bend from trail damage, and small rocks can wedge between the plate and the rotor, causing noise and damage. For years the company cut out the center of the stock plate and reassembled the axle with only the spacing ring. The eliminator rings are a cleaner way to do the same thing, and they are the same thickness as stock for proper component spacing.
Key features
- Two spacer rings that take the place of the factory backing plate
- Same thickness as stock, so component spacing stays correct
- Removes the plate that can bend on the trail or trap small rocks
- Direct-fit listing for front Toyota solid axles
- Installs when the knuckle is being serviced
Backing plates and trail damage
The backing plate sits behind the brake rotor and carries the brake shoes or pads and their hardware. On a trail truck, that plate sits low and exposed, so it can take hits from rocks and stumps. A bent plate can rub the rotor, and small stones can wedge between the plate and rotor, causing noise and wear.
Removing the plate is a bigger change than it looks, so plan the job around the knuckle service. Check the brake line routing once the plate is gone, and confirm the lines have clearance from the axle and suspension. Test the brakes at low speed before any trail use.
- Check brake line clearance after removal
- Inspect the rotor for rub or scoring
- Test brakes at low speed before trail use
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140058-1-KIT |
| UPC | 70000621539 |
| Product type | Brake backing plate eliminator kit |
| Quantity | Two rings |
| Axle | Front Toyota solid axle |
| Thickness | Same as the stock backing plate |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1984-1985 Toyota 4Runner and the 1979-1985 Toyota Pickup.
Confirm fit for your vehicle’s year, model and trim before ordering, since Toyota models after 1985 are outside this fitment.
Installation notes
Remove the stock backing plate and install its spacer ring while the knuckle is being serviced. The rings have no mount for the brake line, so the lines may need another mounting or routing method.
What’s included
Two brake backing plate eliminators.
Not included: brake line brackets or other line-routing parts.









