Overview
The Westin Snyper Pillar LED Light Mount, part number 62-41035 and UPC 707742072103, is a lower pillar mount for single post LED lights, built to hold a 50 in. light bar on the 2007–2018 Jeep Wrangler JK. It fits the 2007–2018 Jeep Wrangler JK generation.
The mount is made from 7 gauge mild steel with a textured black finish, which Westin says complements OEM vehicle trim. Stainless steel fasteners support corrosion protection, and foam gaskets are included to protect the vehicle finish. The light bar is not included.
Key features
- 7 gauge mild steel construction
- Built to sustain the weight of a 50 in. light bar
- Stainless steel fasteners for corrosion protection
- Textured black finish that complements OEM trim
- Foam gaskets to protect vehicle finish
- Lower pillar design for single post LED lights
Lower pillar mounting considerations
A lower pillar mount puts a light bar at a different height than a roof mount, which changes both the beam pattern and the load on the pillar. Position the bar so it clears the hood and the mirror, then check the aim on level ground. The steel body gives a firm base, but the bar’s weight still needs to sit square on the mount.
Stainless fasteners resist corrosion, which matters when the mount lives in road spray and mud. Wipe grit off the mounting area before tightening so it does not scratch the textured black finish. The foam gaskets protect the paint, and they should be checked whenever the mount is removed.
Plan the wiring before final assembly. Keep the harness clear of the door hinges and the windshield wipers, and use a fused relay for any powered light so the switch carries only a small load.
- Set the bar height before tightening
- Check the foam gaskets when removing the mount
- Use stainless fasteners for service
- Route the harness away from hinges
Specifications
| Brand | Westin |
|---|---|
| Part number | 62-41035 |
| UPC | 707742072103 |
| Material | 7 gauge mild steel |
| Fasteners | Stainless steel |
| Finish | Textured black |
| Light bar size | 50 in. |
| Mount type | Lower pillar for single post LED lights |
| Gaskets | Foam, included |
| Fitment listing | Direct Fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler JK, including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport and X trims in two-door form, and the Unlimited versions of those trims in four-door form.
TJ, LJ and JL generations are not in this list. Compare your JK body style and trim with the names above first.
Installation notes
Use a fused relay for any lighting wire, and check road-use rules for auxiliary lights where you drive. Measure clearance around the light bar before tightening the final fasteners.
What’s included
Foam gaskets are included. The light bar is not included.









