Overview
The Smittybilt 90101 is a drill-in style windshield channel (header) for installing brief tops on a Jeep that does not have a factory soft top windshield channel. Drilling is required for installation.
Before you drill
A windshield channel holds the top edge of a soft top against the windshield frame, so its fit controls how the top seals and how much wind and water reach the cabin. Because this channel is drill-in, the holes are permanent. Lay it on the frame and check the alignment along the whole length before a single hole is marked.
Brief tops depend on a tight seal and square fit. Clean the frame and the contact area thoroughly, since grit and old adhesive stop the seal from sitting flush. Mark each hole position on the channel and frame, then drill slowly and deburr the edges. Recheck the top and fasteners after the first few drives to catch any gap early.
- Dry-fit the channel before drilling
- Use a sharp bit and drill slowly
- Deburr holes and clean away metal shavings
Specifications
| Brand | Smittybilt |
|---|---|
| UPC | 631410068184 |
| Product type | Windshield channel (drill-in style header) |
| Installation | Drilling is required |
| Fit type | Direct fit |
Vehicle fitment
This channel is for Jeeps that lack a factory soft top windshield channel. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Slide the channel over the windshield frame edge by edge, and test the fit along the whole length before the top or glass is closed up against it. Clean the contact area so the seal sits flush.






















