Overview
The Smittybilt Tire Relocation Bracket, part number 7721, is a bolt-on bracket for the 2018-2026 Jeep Wrangler (JL), in 2-door and 4-door models. It repositions the spare tire up to 1.5 inch out and 1.5 inch upward, which Smittybilt says gives the clearance needed for many aftermarket bumper and tire setups larger than 33 inch.
The bracket is made from 3/16-inch laser cut steel and weighs 11 pounds. It is designed to carry an oversize wheel and tire. It mounts at the OE attachment points, so installation requires no drilling. The OE brake light and camera functions are retained without modification, and the OE rubber isolator is kept to reduce vibration.
Key features
- Moves the spare tire 1.5 inch out and 1.5 inch up
- Uses OE attachment points
- Retains OE brake light and camera functions
- 3/16-inch laser cut steel
- OE rubber isolator retained
- Light texture black finish
- Smittybilt Advantage warranty
Before you buy
Relocating a spare tire changes how the whole rear of a Wrangler JL works. The spare moves outward and upward, so the tailgate, the spare’s swing path and the rear bumper all need to clear one another. Before ordering, measure your tire’s overall diameter and width, and compare them with the tire sizes this bracket supports. A larger tire also adds weight at the rear, which affects the suspension and the rear bumper mounts over time.
Look at the wheel and tire you plan to run as well as the bumper. Wider tires can need additional spacing from the body, and a heavier spare increases the load on the bracket’s attachment points. Check the bolts and the OE mount after the first few trail runs, and again after any hard impact to the rear of the vehicle. Look for loosening, cracks at the welds or paint wear that shows movement.
- Measure tire diameter and width before buying
- Confirm tailgate and spare swing clearance
- Inspect attachment points after rough trail use
- Recheck fasteners after the first few runs
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 7721 |
| UPC | 631410140873 |
| Material | 3/16-inch laser cut steel |
| Finish | Light texture black |
| Spare tire capacity | Up to 35 inch; 37 inch with reinforcement bracket |
| Wire extension | Not needed for up to 35 inch spare |
| Installation | Bolt-on, no drilling |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2018-2026 Jeep Wrangler JL, in 2-door and 4-door models. The 2018-2026 years cover the JL generation.
It does not fit the JK, JK Unlimited or the JT Gladiator, so match your year, model and trim before ordering.
Installation notes
The bracket is bolt-on and uses the OE attachment points, so no drilling is required. A swing gate reinforcement is recommended for 35 inch tires and required for 37 inch tires.






































