Overview
The Rough Country UTV LED Bumper Wings in black, part R/C93044, are front bumper panels with 6-inch LED light bars for Polaris Ranger UTVs. They install directly on the factory front bumper and add front-end lighting with a more aggressive look.
Each 11-gauge powder coated steel panel holds a 6-inch Rough Country Slimline LED light bar rated at 2,880 lumens. The light bars are IP67 waterproof and use die cast aluminum housings, and a moisture breather reduces moisture build-up behind the lens. The panels run to the edge of the front end for a sleek, modern look.
Key features
- 11-gauge powder coated steel panels
- Two 6-inch Slimline LED light bars
- IP67 waterproof rating
- Die cast aluminum housings
- Moisture breather reduces build-up behind the lens
- Expandable rubber mounts
- Wiring harness with on/off switch
- 3 year warranty
Light output and wiring
LED light bars on the front of a utility vehicle are useful for trail work, camp setup and low-light driving on work sites. Placement matters: panels set low on the bumper light the ground ahead, which suits technical terrain. Keep the lights aimed to avoid dazzling oncoming operators, and check local rules before using auxiliary lights on public roads.
The harness runs to a switch so the lights can be turned off when not needed. Before wiring, disconnect the battery and route the cable away from hot exhaust parts and moving suspension. Look over the seals around each light after rough use, since a cracked lens or a damaged seal can let moisture reach the housing.
- Route the harness clear of heat and moving parts
- Check light aim after each install
- Inspect lens seals after rough trail use
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C93044 |
| Finish | Black |
| Position | Front |
| Panel material | 11-gauge powder coated steel |
| Light bars | Two 6-inch Slimline LED |
| Light output | 2,880 lumens per light bar |
| Housing | Die cast aluminum |
| Waterproof rating | IP67 |
| Mounting | Installs directly on the factory bumper, with expandable rubber mounts |
| Wiring | Harness with on/off switch |
| Warranty | 3 years |
Vehicle fitment
Rough Country lists these bumper wings for the Polaris Ranger 900 XP from 2013 to 2017, the Ranger XP 1000 from 2017 to 2026, the Ranger Crew XP 900 from 2017 to 2019, the Ranger Crew XP 1000 from 2017 to 2026, and the Ranger 1000 and Ranger Crew 1000 from 2020 to 2026.
Ranger 1000 models from before 2020 are not covered, and the Ranger 570 is not a fit. Models from before 2013 are also outside the fitment, and Highlifter Edition units are not compatible. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Cutting or trimming the factory bumper is required before the panels can mount. The lights run through the included wiring harness and on/off switch, so wiring is part of the install. Disconnect the battery before running the harness.
What’s included
Two bolt-on shroud plates, two 6-inch slimline LED light bars, two expandable rubber mounts, a wiring harness with on/off switch, and hardware.














