Overview
The Rock Slide Engineering third brake light kit, part BL-RB-100-JK, is an LED third brake light built for the center cap of a spare tire mount. It is universal fit and not tied to one year, make or model. Measure your spare tire mount’s center cap before ordering to confirm the kit suits it.
Key features
- LED third brake light
- Built for the center cap of the spare tire mount
- Universal fit
- Rock Slide Engineering part BL-RB-100-JK
Third brake light wiring basics
A third brake light is a separate lamp from the rear light pair, and it usually runs off the brake light circuit. LED units draw less current than bulbs, but they still need a clean ground and a stable voltage to light evenly. Test the brake and turn functions before closing up any panels, because a wiring error can be hard to trace once the trim is back in place.
Route the wires away from moving parts, hinges and exhaust heat, and secure every run with clips. On a spare tire mount, flexing and water are the main threats, so seal each connector with dielectric grease or heat-shrink tubing. Check the lens after rough trails, since a loose or cracked lens lets moisture into the housing.
Specifications
| Brand | Rock Slide Engineering |
|---|---|
| Part number | BL-RB-100-JK |
| UPC | 887753114020 |
| Light type | LED |
| Mounting location | Center cap of the spare tire mount |
| Fitment | Universal fit |
Vehicle fitment
Universal fit is listed, so this kit is not tied to a specific vehicle year, make or model. Confirm the kit suits your spare tire mount before installing.
Installation notes
Use a fused circuit for the brake light wiring and check local rules for third brake lights before road use.
What’s included
Check the wiring, hardware and mounting parts against your installation before starting.
















