Overview
The Rigid Industries 41578 is a black front grille with an RDS-Series LED light bar for Dodge Ram 2500 and 3500 trucks. It is laser-cut 304 stainless steel with a custom mesh pattern, built with no weld and finished in polyester powder coat.
The kit is positioned at the front of the truck and comes with stainless steel hardware, a novelty Rigid Industries grille emblem and the light bar. Light bar size is given as 20-inch in one place and 30-inch in another, so confirm the size before ordering.
Key features
- Laser-cut 304 stainless steel grille
- Custom laser-cut mesh pattern
- Built with no weld
- Polyester powder coat in black
- RDS-Series LED light bar included
- Novelty Rigid Industries grille emblem included
- Stainless steel mounting hardware included
- Made in the U.S.A.
- Limited lifetime warranty
Fused wiring for an auxiliary bar
An auxiliary light bar on a Ram grille adds load to the truck’s electrical system, so the wiring deserves as much attention as the grille itself. Use a fused relay close to the battery, route the cable through loom and keep it clear of heat, belts and sharp edges. A switch on the dash lets you control the bar without drawing current through a small circuit.
Because the grille carries a full light bar, the mounting surface should be checked after the first few trail runs. Vibration can loosen fasteners, so recheck the bolts and nuts and look for any shifting. A small amount of thread locker on the mounting hardware can help some installs, though the hardware instructions should be followed first.
Powder coat on steel grilles can chip where cables or tools rub. Clean any spots with mild soap and touch up chips with a matching paint kit to slow corrosion.
- Use a fused relay near the battery
- Keep the switch circuit separate from the bar wiring
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 41578 |
| Position | Front |
| Material | 304 stainless steel |
| Finish | Black polyester powder coat |
| Construction | Laser-cut, no weld |
| Light bar | RDS-Series LED, 20-inch or 30-inch (see overview) |
| Included | Grille emblem and stainless steel hardware |
| Country of manufacture | U.S.A. |
| Warranty | Limited lifetime |
Vehicle fitment
It fits the 2010 Dodge Ram 2500 and 3500 and the 2011–2012 Ram 2500 and 3500. For the 2010 Ram 2500, the trims are Laramie, Power Wagon, SLT, ST, SXT and TRX. The 2010 Ram 3500 covers Laramie, SLT, ST and SXT. The 2011–2012 Ram 2500 and 3500 cover Laramie, Laramie Longhorn, SLT and ST, with Outdoorsman and Power Wagon also on the 2500.
The Ram 1500 and any Ram 2500 or 3500 model year after 2012 are not covered by this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The light bar is included, so plan to wire it through fused relay wiring. Check local road-use rules for auxiliary lights before driving with the bar switched on.
What’s included
The kit includes the grille, the RDS-Series LED light bar, the Rigid Industries grille emblem and stainless steel mounting hardware.












