Overview
The Rhino-Rack Pioneer Leg Height Spacers (PLHSPAIR) are used to level a Pioneer roof rack system on a vehicle. The spacer sits between a Rhino-Rack RLCP or RL leg and a Pioneer platform or tray, and it raises the Pioneer by roughly 75 mm overall. That extra height lets the legs slide out wider, so one Pioneer can fit a wider range of vehicles, and a narrower tray can be chosen instead of a larger one. The spacers are universal fit rather than made for a particular vehicle.
Key features
- Raises the Pioneer platform or tray by about 75 mm overall
- Lets the legs slide out wider to fit more vehicles
- Allows a narrower tray or platform in place of a larger one
- Includes two 10 mm spacer blocks and all necessary hardware
Choosing the right setup
Leg height spacers change how far a roof rack sits above the vehicle, which affects clearance for the load, doors and hatch. Before adding height, look at the whole stack: the platform or tray, the legs and the fixings all need to work together, and a taller setup puts more leverage on the mounting points. Measure the gap you need between the roof and the rack before choosing a tray size.
Spacers are often bought alongside a different platform size, since extra height can allow a narrower tray with the same legs. When changing setup, check that cables, roof accessories and any roof-mounted lights still clear the new height. Re-tighten all fixings after the first short drive, and look over the legs and spacers at intervals for loose bolts or wear marks.
Specifications
| Brand | Rhino-Rack USA |
|---|---|
| Part number | RHOPLHSPAIR |
| Height gained | About 75 mm overall |
| Included spacer blocks | Two, each 10 mm |
| Maximum stack | Three spacers, as recommended by Rhino-Rack |
| Compatible with | Rhino-Rack RLCP or RL legs and Pioneer platforms or trays |
| Not for | Roof rack crossbars |
Vehicle fitment
The spacers are universal fit, so they are not built for one vehicle. The right size of Pioneer tray or platform depends on your vehicle, so confirm the choice for your vehicle’s year, model and trim before ordering.
Rhino-Rack states these spacers are not suitable for roof rack crossbars. Confirm the leg and platform combination before ordering.
Installation notes
All the hardware is supplied. Fit each spacer between the leg and the platform or tray. Only one PLHSPAIR is needed. If more height is required, two LHSPAIR spacers can be used with the PLHSPAIR, and Rhino-Rack recommends a maximum of three spacers in the stack.
What’s included
All hardware and two 10 mm spacer blocks.












