Overview
The Warrior 1558 is a rear corner license plate mount for the 1997-2006 Jeep Wrangler TJ, including Wrangler, Rubicon and Unlimited models. It is made from 11-gauge steel with a black powder coat finish, and it installs by reusing the existing bolts at the rear corner.
The mount is compatible with OEM tail lights and rear corners, as well as Warrior’s Steel LED Tail Lights and Rear Corners. It keeps the license plate illuminated from the existing license plate light. The mount can also serve as a step to reach gear placed on a roof rack.
Key features
- Rear corner mount for the 1997-2006 Jeep Wrangler TJ
- 11-gauge steel construction with black powder coat for rust prevention
- No cutting or drilling required
- Reuses existing bolts for installation
- Keeps license plate illumination from the existing light
- Compatible with OEM and Warrior Steel LED tail lights and rear corners
- Rubber edge trim protects the vehicle paint
- Made in the USA
Corner mount care and upkeep
A rear corner mount takes the weight of the plate and frames the rear corner, so the points where the bolts seat are the places to inspect first. Look for rust around the bolt holes and check that the rubber edge trim still seals against the paint. Surface rust on steel with a black powder coat can be cleaned and touched up, while deep corrosion calls for replacement.
If you run a roof rack or add rear lighting, the mount’s position and wiring matter more. Keep the license plate lamp connected so the plate stays lit, and recheck the alignment after reinstalling any tail light or corner piece. Clean salt and mud from the mount at intervals to keep the finish protected.
- Inspect bolt holes for rust each season
- Check the rubber trim for cracks or lifting
- Recheck alignment after work near the tail lights
- Keep the plate lamp wired and working
Specifications
| Brand | Warrior |
|---|---|
| Part number | 1558 |
| UPC | 634146155869 |
| Material | 11-gauge steel |
| Finish | Black powder coat |
| Drilling | Not required |
| Light | Does not include light |
| Fitment type | Direct fit |
| Country of manufacture | Made in the USA |
Vehicle fitment
It fits the 1997-2006 Jeep Wrangler TJ, including Wrangler, Rubicon and Unlimited models.
Only TJ models are covered, so other Wrangler generations such as the JK are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Warrior describes installation as removing a few existing bolts, aligning the license plate mount and threading the bolts back in. No cutting or drilling is needed. Check the alignment at the rear corner before fully tightening the bolts, and keep the license plate light connected so the plate stays lit.
What’s included
Includes all hardware to affix the license plate to the mount, plus rubber edge trim to protect the vehicle’s paint.
Not included: The license plate light.
















