Overview
The Poison Spyder License Plate Mount, part number 18-04-012-02, relocates the license plate of a Jeep Wrangler JK to the center of the tailgate. It is designed for the 2007–2018 Jeep Wrangler (JK), in two-door and four-door models.
The mount uses four of the OE spare tire mount bolts and is offset so the tailgate vents still work. Poison Spyder suggests it for owners who run without a tailgate-mounted spare tire.
Fit depends on the shape of the tailgate vent. The mount is designed for the wide vent, which is wider than it is tall and generally found on 2010 and newer models and on some 2009s. Tall-vent JKs, typically 2007 to 2009, may also use it, though the vent edges can remain visible above and below the plate.
Key features
- Relocates the license plate to the center of the tailgate
- Uses four of the OE spare tire mount bolts
- Offset to clear the tailgate vents
- No drilling required
- Steel with black powder coat finish
Plate placement and visibility
A relocated plate should stay visible and readable from the rear. Check your local rules on plate placement and lighting before moving the plate, since some areas require a lit plate that can be seen at night. If you still use a spare tire carrier, keep the plate clear of it, and confirm the plate does not block the rear glass.
Tailgate-mounted accessories add weight to the tailgate and hinge area. Recheck the mount bolts after rough trail use, and inspect the hole left behind by the factory plate mount. A cover over that hole keeps water and dirt out of the tailgate.
- Check local plate and light rules
- Recheck bolts after rough use
- Cover the factory plate mount hole
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 18-04-012-02 |
| UPC | 614901727463 |
| Material | Steel |
| Finish | Black powder coat |
| Drilling | Not required |
| Light | Not included |
| Models | 2-door and 4-door Jeep Wrangler JK |
Vehicle fitment
This mount is designed for the 2007–2018 Jeep Wrangler (JK), with the vent-shape caveat above.
The mount is built for the wide tailgate vent. On tall-vent JKs, the edges of the vent may still be visible above and below the plate. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mount attaches with four of the OE spare tire mount bolts and does not need drilling. Poison Spyder recommends its Stock License Plate Delete Cover, part PSC17-04-112, to fill the hole where the factory plate mount was.
The four bolts are the factory spare tire mount bolts, so the mount reuses hardware already on the tailgate.
What’s included
One license plate mount.
Not included: a light.









