Overview
The Poison Spyder LED License Plate and 3rd Brake Light Connector, part number 41-06-040, is a steel license plate light made to plug directly into Poison Spyder’s proprietary JK LED Taillight Harness on the passenger side. It is written for the Jeep Wrangler JK, 2007 to 2018, and it mounts to the two upper license plate bolts.
The connector is one piece of a series of Poison Spyder LED lighting products that are meant to work together. The series snaps into the Jeep’s wiring harness without cutting or splicing, which is the point of the connection system rather than a separate wiring job. The light draws little power because it uses LEDs.
Key features
- Connects directly to the JK LED taillight harness, passenger side
- Mounts to the two upper license plate bolts
- Light included with the connector
- Weatherproof wiring connection system
- LEDs with low power draw
- No drilling required
LED lighting and wiring connections
A plug-in lighting connector saves time, but its reliability depends on the wiring it joins. Look at the harness plug for bent pins, corrosion or cracked insulation before connecting. A weatherproof plug only keeps water out when it is fully seated and the seal is clean, so push it home until it clicks and inspect the seal during routine checks.
Third brake lights and license plate lights are often replaced together when a rear lighting upgrade is planned. Check that brake lights and turn signals work after the connection is made, since a dim or flickering light can point to a poor ground or connection. Keep spare plugs and a small amount of dielectric grease on hand, and check the lamp housings for condensation after wet trips.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 41-06-040 |
| UPC | 614901736618 |
| Light type | LED license plate and third brake light |
| Harness | JK LED taillight harness, passenger side |
| Mounting | Two upper license plate bolts |
| Drilling | Not required |
| Light included | Yes |
| Material | Steel |
| Connection | Weatherproof wiring connection system |
Vehicle fitment
This connector is made to plug into the Poison Spyder JK LED Taillight Harness on the passenger side, so it is written for the Jeep Wrangler JK from 2007 to 2018. It does not plug into the Jeep’s factory wiring, and it is not intended for other vehicles or wiring systems.
Confirm your vehicle’s year, model and trim before ordering. For other vehicles and wiring systems, a generic connector is sold separately.
Installation notes
No drilling is needed, because the plate mounts to the two upper license plate bolts. Connect the weatherproof plug to the JK taillight harness. Check local rules on license plate and brake lighting before using the light on public roads.
What’s included
The LED license plate and third brake light with the weatherproof wiring connection.
Not included: the JK LED taillight harness, which is needed to connect the light.









