Overview
The PCI Race Radios X3 Pillar Side Panels, part number 2979, are black side panels that finish off the X3 pillar replacement bracket. They fit the 2017–2021 Can-Am Maverick X3 and Maverick X3 Max.
The panels work with both Kenwood and Icom radio pillar brackets, so the same panels fit whichever radio bracket is in use. PCI says they give the pillar a neat look.
Key features
- Black finish
- Side panels for Kenwood and Icom radio pillar brackets
- Gives the X3 pillar bracket a neat finish
- Mounting solutions designed to simplify installation in most UTVs.
Mounting and bracket checks
Side panels affect more than appearance. They sit against the bracket and the side of the dash, so the mounting points have to hold them firmly under vibration. Check each fastener after the first few rides and after any rough trail section, since loose panels can rattle and wear the finish around the bracket.
Panel clearance matters around the seat area and any roll cage or harness hardware. Fit the panels with the seat installed and the harness routed as normal, so you can see whether anything presses against them. Dirt that builds up behind the panels can hold moisture, so clean the area when you service the bracket.
- Confirm the bracket type matches your radio
- Test clearance with the harness in place
- Re-tighten fasteners after rough terrain
Specifications
| Brand | PCI Race Radios |
|---|---|
| Part number | 2979 |
| Finish | Black |
| Compatible brackets | Kenwood and Icom radio pillar brackets |
Vehicle fitment
PCI Race Radios lists these panels for the 2017–2021 Can-Am Maverick X3 and the 2017–2021 Maverick X3 Max, across the listed Turbo and X-series editions of each model.
The panels are made for the X3 models only, so the fit depends on the model you own.
Installation notes
The side panels are designed to go with the X3 pillar replacement bracket, so the bracket is the item they attach to. Check the bracket type for your radio before fitting the panels.










