Overview
The Omix-ADA transmission mount, part 18608.09, is a direct OE replacement mount for Jeep AX5 and AX15 transmissions. Omix-ADA builds its Jeep parts to the original specifications, so the mount is meant to match the factory design rather than change it. The manufacturer backs it with a limited five year warranty.
Owners looking for an AX5 or AX15 transmission mount will find a straight replacement for the original part, with the brand, part number and UPC shown in the specifications below.
Mount wear and replacement
A transmission mount holds the drivetrain in place under torque and absorbs vibration from the engine and transmission. As the rubber ages it can crack, separate from its metal plates or sag, which often shows up as clunks on shifts, shaking at idle or a transmission that sits lower than before. Inspect the mount and its crossmember whenever you work under the vehicle.
When replacing a mount, support the transmission with a jack and block before removing the old bolts so the drivetrain does not drop. Because the mounts share the load, inspect the nearby mounts for similar wear and check the crossmember for cracks or sagging. Torque the new bolts to the value the hardware requires and recheck them after a short drive.
- Look for cracks or separation in the rubber
- Check for clunks when shifting from park
- Inspect bolts and bracket holes for wear
- Support the transmission before loosening bolts
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18608.09 |
| UPC | 804314050481 |
| Transmission application | AX5, AX15 |
| Mount type | Direct fit OE replacement |
| Warranty | It carries a limited five year warranty. |
Vehicle fitment
It is a direct fit for Jeep AX5 and AX15 transmissions. Confirm the transmission type and your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.













