Overview
The Omix-ADA 16730.07 is a driver side rear emergency brake cable for 1976–1978 Jeep CJ models with 11 inch brakes. It fits the CJ5 and CJ7. It measures 33 inches and has a bolt-on style end at the backing plate.
It is the rear left cable for the driver side.
Key features
- Rear left emergency brake cable
- Made for 11 inch brakes
- Length of 33 inches
- Bolt-on style end for the brake backing plate
Driver side cable service
The driver side rear cable runs from the equalizer to the brake on the left rear wheel. Because it carries the same load as the passenger cable, a problem on one side often shows up as uneven parking brake pull. Check the sheath for corrosion, the cable for stiff movement, and the anchor points where the cable is held to the axle or frame.
Before fitting a new cable, confirm the length matches the old one by laying them side by side on a bench. A cable that is too long can bind at the bend, while one that is too short will not reach the lever. After installation, adjust the rear brakes so the lever engages at a consistent height, then test on a gentle grade.
- Compare the new cable with the old one side by side
- Check sheath and anchor points for rust
- Test the lever on a gentle slope after adjusting
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16730.07 |
| UPC | 804314034634 |
| Part type | Emergency brake cable |
| Position | Rear left, driver side |
| Brake size | 11 inch |
| Length | 33 inches |
| Backing plate end | Bolt-on style |
| Fit type | Direct fit |
| Warranty | It carries a limited five year warranty. |
Vehicle fitment
It fits the 1976–1978 Jeep CJ5 and the 1976–1978 Jeep CJ7.
It is built for 11 inch brakes on the driver side. Other CJ years are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The cable end that goes into the brake backing plate is a bolt-on style end, so check that your backing plate matches.









