Overview
The Omix-ADA 16730.06 is a passenger side rear emergency brake cable for 1976–1978 Jeep CJ models with 11 inch brakes. It fits the CJ5 and CJ7. It measures 63 inches, and the end that goes into the brake backing plate is a bolt-on style end.
It is the rear right cable for the passenger side.
Key features
- Rear right emergency brake cable
- Made for 11 inch brakes
- Length of 63 inches
- Bolt-on style end for the brake backing plate
Before you install
A rear parking brake cable carries pull from the equalizer to the brake shoe lever at each rear wheel. On drum brakes like these, the cable end seats in the backing plate and works the shoe, so the end must engage cleanly before the cable is tensioned. Examine the old cable for fraying, kinks, rust at the housing and a sleeve that no longer slides. A stretched cable lets the lever travel too far, and a seized one can keep the shoe partly applied after release.
When one rear cable is replaced, compare routing with the opposite side and confirm the guide clips along the frame are intact. Cables of the same age often wear together, so inspecting both is practical. Lightly lubricate the pivots and keep grease off the brake lining.
- Seat the backing plate end fully before tightening
- Inspect the housing for cracks and rust
- Confirm the cable clears frame clips and crossmembers
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16730.06 |
| UPC | 804314034627 |
| Part type | Emergency brake cable |
| Position | Rear right, passenger side |
| Brake size | 11 inch |
| Length | 63 inches |
| Backing plate end | Bolt-on style |
| Fit type | Direct fit |
| Warranty | It carries a limited five year warranty. |
Vehicle fitment
It fits the 1976–1978 Jeep CJ5 and the 1976–1978 Jeep CJ7.
It is built for 11 inch brakes. Other CJ years are not covered, and the driver side cable is a different part. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The cable end that goes into the brake backing plate is a bolt-on style end, so check that your backing plate matches.














