Overview
The Omix-Ada 18018.07 is a clamp for the lower power steering shaft coupler on Jeep CJ5, CJ7 and Scrambler models. It is a direct fit for 1976–1983 CJ5, 1976–1986 CJ7 and 1981–1985 Scrambler vehicles.
This clamp secures the coupler at the lower shaft, so the part number and fit range are the main points to match before ordering.
Key features
- Clamp for the lower power steering shaft coupler
- Direct-fit listing for three vehicle entries
- Built to original specifications
- Part number 18018.07 with UPC 804314021627
Keeping the coupler secure
A coupler clamp holds the lower shaft to the steering box and keeps the joint from pulling apart under load. On a CJ it works against vibration from rough roads and trails, so a loose clamp can let the coupler shift and make the wheel feel slack when you turn. Replacing a worn clamp is a small job that protects the steering connection.
Before tightening, make sure the clamp seats square over the coupler and clears nearby brackets and the frame. Look at the bolt threads and the clamp body for rust or stretch, since a damaged clamp may not hold its position. Check the clamp again after the first few drives and whenever the steering box or coupler is disturbed.
- Check that the clamp sits square on the coupler
- Inspect the bolt threads for rust
- Recheck the clamp after the first drives
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18018.07 |
| UPC | 804314021627 |
| Position | Lower |
| Part type | Clamp for power steering shaft coupler |
| Warranty | Limited five year manufacturer warranty |
Vehicle fitment
It fits 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade) and 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR) models.
Wrangler YJ and later Jeep models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.









