Overview
The N-Fab T014LB-TX is a textured black front light bar mounting kit that holds up to four 9 inch lights. It is a direct fit for the 2001–2004 Toyota Tacoma in Base, Pre Runner and S-Runner trims. The kit uses an all bolt-on design.
N-Fab builds the mount from heavier gauge .084 wall steel in a one-piece welded (non-modular) construction. Each part is zinc coated for corrosion protection and finished with a powder coat. The kit is made in the U.S.A. The lights are not included and need to be sourced separately.
Key features
- Holds up to four 9 inch lights
- Textured black finish
- Welded one-piece (non-modular) construction
- Heavier gauge .084 wall steel
- Zinc coated for corrosion protection, then powder-coated
- All bolt-on design that N-Fab says will not flex
- Made in the U.S.A.
Front light bar wiring
Four 9 inch lights draw significant current together, so run them through a fused relay rather than the switch itself. Place the relay and fuse near the battery, and make sure each ground returns to clean bare metal. Keep the harness away from the radiator fan, the hood latch and any winch cable path.
A front bar takes impact from brush, rocks and stream crossings, so the bolts and welds deserve regular attention. Clean mud out of the mounting points after trail use, and look for cracks near the tabs where stress concentrates.
- Use a fused relay for the lamp group
- Keep lights clear of the radiator and hood latch
- Check bolts after rough trail sections
- Inspect welds for cracks after impacts
Specifications
| Brand | Nfab |
|---|---|
| Part number | T014LB-TX |
| UPC | 843206117864 |
| Location | Front |
| Light capacity | Up to four 9 inch lights |
| Construction | Welded, one-piece (non-modular) |
| Steel wall | .084 (heavier gauge) |
| Finish | Textured black |
| Corrosion protection | Zinc coated |
| Coating | Powder-coated |
| Mounting | All bolt-on design |
| Made in | U.S.A. |
| Fitment listing | Direct fit, 2001–2004 Toyota Tacoma |
Vehicle fitment
It is a direct fit for the 2001–2004 Toyota Tacoma in Base, Pre Runner and S-Runner trims.
Other Tacoma generations and other Toyota models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit installs with bolts, although the bar itself is welded. Wire the four lights through a fused relay, and check local road-use rules for auxiliary lights before mounting them.
What’s included
The kit covers the mounting hardware only. Lights are not included.
Not included: The four 9 inch lights the kit is built to hold.









