Overview
The N-Fab F0950LR is a bolt-on forward roof mounted light bar mount. Its powder coated finish is either gloss black or textured black.
N-Fab describes its tubular parts as heavy duty, and this mount uses .084 wall steel in an all-welded, one-piece construction. Zinc coating sits beneath a thick high gloss powder coat, which supports corrosion protection.
Key features
- Forward roof mounted position
- Bolt-on installation
- Drilling required, per the bullet points
- Power coated gloss black finish
- .084 wall steel, all-welded one-piece construction
Before drilling the roof
Drilled mounts depend on accurate layout. Measure twice from a fixed reference point, mark the holes with a center punch, and start with small pilot holes before stepping up to the final size. Check what is above the roof before drilling, including headliner clips, wiring and any roof rack hardware, so no hole lands on something you cannot reach later.
Once the holes are drilled, clean the bare edges and remove burrs so the powder coat and washers sit flat. Bare steel around a cut edge rusts faster than the coated surface, so touch-up paint or a rust inhibitor is a sensible step. Use sealant under the mount base where water could sit, and recheck the hardware after the first few drives on rough ground.
Specifications
| Brand | Nfab |
|---|---|
| Part number | F0950LR |
| Mount position | Forward roof |
| Installation | Bolt-on, drilling required |
| Material | Steel, .084 wall thickness |
| Coating | Zinc coat under powder coat |
| Finish | Gloss black (bullets) and textured black (title) |
Vehicle fitment
It is sold as Direct Fit. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This mount requires drilling and installs bolt-on, so plan for drilled holes before mounting. Route light bar wiring through a fused relay and check local rules before using roof-mounted lights on public roads.
What’s included
Plan the hardware and drilled holes before mounting, and check the package contents against your installation before starting.
Not included: Check that you have the light bar and any mounting hardware you need before starting.












