Overview
The Mountain Off Road Enterprises LS9040 is a front greaseable shackle for the 1987-1995 Jeep Wrangler YJ, with no lift listed. It is cut from 3/8 inch thick steel plate and built to bolt in with a thick walled center brace.
The shackle is secured with grade 5 hardware, and the gold zinc plating is designed to resist corrosion. It adds no lift over stock.
Key features
- Front location
- Cut from 3/8 inch thick steel plate
- Thick walled center brace with grade 5 hardware
- Zinc plated gold corrosion resistance
- No lift over stock
Greasing and upkeep on a YJ
Greaseable shackles work best when the grease fittings are serviced on a regular schedule. Pump grease into each fitting until fresh grease shows at the bushing, which pushes out dirt and water that would otherwise wear the bore. Front shackles on a YJ carry steady load from the leaf spring, so a dry joint can squeak, bind and wear faster than expected.
Inspect the shackle at each service. Check for play by rocking the axle side to side with the spring eye loaded, look for cracks around the center brace welds, and watch for flattened or elongated bushing bores. Any of these signs points to a worn part. Replace shackles in pairs so both front ends wear evenly and alignment stays consistent. Check the spring and frame hardware with the same care whenever the shackle is off.
Specifications
| Brand | Mountain Off Road Enterprises |
|---|---|
| Part number | LS9040 |
| UPC | 70000428376 |
| Location | Front |
| Material | 3/8 inch thick steel plate |
| Hardware | Grade 5 |
| Finish | Zinc plated gold |
| Lift | None |
| Quantity | Pair |
Vehicle fitment
The fitment details for LS9040 cover the 1987-1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Wrangler TJ and later models are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Support the Wrangler’s frame on stands before removing the factory shackle, and line the new shackle up with the spring eye before tightening. Bushing options for BDS, Skyjacker, Trailmaster and Pro Comp springs are mentioned, so ask the manufacturer for details if you plan to use one.
What’s included
A pair of front shackles with a thick walled center brace and grade 5 hardware.
Not included: Bushings are not included.









