Overview
The Key Parts 0485-135 is a driver side replacement tail light body panel for the 1997–2006 Jeep Wrangler (TJ) and 2004–2006 Jeep Wrangler (LJ). It is made from high gauge steel and arrives with an OEM Electro-Deposit primer (EDP) finish.
The panel is made to match original fitment and is a direct fit for the vehicles below.
Key features
- Driver side panel
- High gauge steel construction
- OEM Electro-Deposit primer (EDP) finish
- Designed to match original fitment
Prep and finishing the panel
A replacement body panel is usually installed on bare or primed metal, so the finish matters. The OEM Electro-Deposit primer gives a base layer, but it is not a topcoat. Many owners sand lightly, clean with a wax and grease remover, and apply a color-matched paint once the panel is fitted and aligned.
Test fit the panel before painting. Check the gaps around the lamp opening and the mounting points, and confirm the wiring plug reaches the lamp. Adjust the panel while it is loose, then tighten fasteners and seal any seams where water could enter.
- Clean the panel with a degreaser before painting
- Test fit before final paint
- Seal seams with body-appropriate sealant
- Check the rear floor and quarter area for rust under the panel
Specifications
| Brand | Key Parts |
|---|---|
| Part number | 0485-135 |
| UPC | 70000700336 |
| Position | Driver side |
| Material | High gauge steel |
| Finish | OEM Electro-Deposit primer (EDP) |
| Fitment type | Direct Fit |
Vehicle fitment
It is a direct fit for the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon, and for the 1997–2006 Jeep Wrangler (TJ), including 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X.
Other Wrangler generations, such as the YJ, JK and JL, are not in the listed fitment. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting, since mounting hardware is not part of the panel.









