Overview
The Key Parts 0486-101L is a driver side factory style rocker panel for the 2002–2007 Jeep Liberty (KJ). Rocker panels run along the lower body between the wheel openings and the doors, and this one is made from high gauge steel for rust and collision repair.
The panel has an OEM Electro-Deposit primer (EDP) finish and fits the 2002–2007 Jeep Liberty (KJ) in the 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition and Sport trims.
Key features
- Driver side rocker panel position
- Factory style design.
- High gauge steel body
- OEM Electro-Deposit primer (EDP) finish
- Direct fit for the Liberty KJ
Before you weld a rocker
Rocker panels take road spray, gravel and salt, and the lower edge of the body is where rust tends to start. Before replacing one, look at the floor pinch welds, the door sill and the area behind the inner rocker for flaking metal or soft spots. If the rust reaches the floor or the body mounts, the rocker alone will not fix the problem, so plan for that repair too.
Good prep makes welding cleaner. Grind the mating edges to bare metal, check that the new panel sits flush with the doors and fenders before tacking it, and keep the old panel for reference until the fit is confirmed. Protect the interior from sparks and apply corrosion protection to any bare metal once the weld is done.
- Probe the floor and pinch welds for soft metal
- Test-fit before final welding
- Seal and coat bare metal after welding
Specifications
| Brand | Key Parts |
|---|---|
| Part number | 0486-101L |
| UPC | 70000700344 |
| Position | Driver side, rocker panel |
| Style | Factory style |
| Material | High gauge steel |
| Finish | OEM Electro-Deposit primer (EDP) |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers the 2002–2007 Jeep Liberty (KJ) in the 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition and Sport trims. The list does not include the Wrangler or Grand Cherokee.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rocker panels are usually welded in place, so the job calls for cutting out the old section and welding in the new one. Wear eye protection when cutting and welding.
What’s included
Check the package contents against your installation before starting.









