Overview
The Key Parts 0482-101L is a driver side factory style rocker panel for the 1984–2001 Jeep Cherokee XJ, fitting 2-door and 4-door models. A rocker panel is the lower body panel below the doors, used to repair rust or collision damage along that edge. It is designed to match factory fit.
The part is made from high gauge steel and carries an OEM Electro-Deposit primer (EDP) finish. It is a welded-in body panel rather than a bolt-on accessory.
Key features
- Driver side rocker panel
- Fits 2-door and 4-door models
- High gauge steel construction
- OEM Electro-Deposit primer (EDP) finish
- Designed to replicate OEM fitment
Rocker repair and door fit
Rocker panels sit below the doors and take splash, road salt and stone strikes, so they are a common rust area on older Cherokee bodies. Repairs usually start by removing the rusted section down to solid metal, then checking the door sill and the floor edge for damage that the new panel will need to meet. Fit the new panel before final welding to check its alignment.
Expect to adjust the door gap during fitting, since small shifts in the rocker can change how the door closes. Recheck the seams for even spacing and fresh primer coverage after welding. Seal and coat the seams on the outer and inner faces to slow future rust, and recheck door operation after the paint has cured.
- Cut back to solid metal before fitting
- Check door gap and alignment before final welding
- Seal seams on both faces to slow rust
- Recheck door closing after the paint cures
Specifications
| Brand | Key Parts |
|---|---|
| Part number | 0482-101L |
| UPC | 70000700308 |
| Side | Driver |
| Body styles | 2 and 4-door models |
| Material | High gauge steel |
| Finish | OEM Electro-Deposit primer (EDP) |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1984–2001 Jeep Cherokee XJ in Base through Sport trims.
It is for Cherokee XJ models only. Confirm your year, model and trim before ordering, since other Jeep models and years outside 1984 through 2001 fall outside this fit.
Installation notes
Rocker panels are welded to the body, so the job means cutting out the rusted rocker and welding the new panel in place. Expect to match the door gap and check the fit before final welding.
What’s included
One driver side rocker panel is included.
Not included: welding supplies, paint and any separate door or pillar panels.









