Overview
The Go Rhino 5912231T is a front light plate for the Go Rhino SRM100 roof rack. It holds two 3-inch cube lights and a 20-inch bar, so you can add lighting to the front of the rack. It is made of steel and needs no drilling.
The plate is designed to customize the SRM100 rack and is a universal fit, so match it to the SRM100 rack model rather than to a vehicle.
Key features
- Holds two 3″ cube lights
- Carries a 20″ bar
- Front placement on the SRM100 rack
- Steel construction
- Drilling is not required
Wiring auxiliary lights
Auxiliary lights on a roof rack draw current through a long run of wire, so the circuit needs a fuse close to the battery and a solid ground connection. Route the harness along the rack crossbar and secure it with clips so it does not rub or snag in wind. Use weather-sealed connectors at every joint, since rain and road spray reach the front of the rack first.
A switch lets you run the lights only when needed, which reduces battery drain and keeps the lights from glaring at oncoming traffic. Aim the lights low and check their angle after the first few drives. Inspect the wiring and connectors each season for chafing, corrosion or loose terminals, and replace any damaged sections before they cause a short.
- Fuse the circuit close to the battery
- Use weather-sealed connectors
- Check aim and wiring after rough drives
Specifications
| Brand | Go Rhino |
|---|---|
| Part number | 5912231T |
| UPC | 887753147257 |
| Material | Steel |
| Drilling required | No |
| Lights held | Two 3″ cube lights |
| Bar | 20″ bar |
| Fitment | Universal Fit |
Vehicle fitment
This plate is a universal fit and is designed for the Go Rhino SRM100 roof rack. Confirm your rack model first, and check mounting points before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
No drilling is needed. Use fused wiring for the cube lights and check local road-use rules for auxiliary lighting before installing.









