Overview
The Go Rhino 5912232T is a rear light plate for the Go Rhino SRM100 roof rack. It holds two 3″ cube lights and a 20″ bar at the back of the rack. The plate is steel and installs without drilling.
It is a Universal Fit part sized for the SRM100 rack rather than a particular vehicle, so the rack model decides compatibility.
Key features
- Mounts two 3″ cube lights at the rear of the rack
- Accepts a 20″ bar
- Steel construction
- Drilling is not required
Wiring and light placement
Roof-mounted cube lights sit high and exposed, so the wiring needs as much planning as the mounting. Plan a route from the plate down a rack leg or pillar and into the cab, keeping slack in the harness so the rack can flex without pulling on connectors. Seal every joint, and keep cables away from moving parts and sharp roof edges.
Most setups run the lights through a switch, a fuse and a relay so the cube lights draw power from the battery rather than from a factory circuit. Choose a fuse rated for the combined draw of every light, and check that the relay handles it. Lights of different output draw different current, so size the circuit to the full load.
- Check cable clearance at rack legs and roof edges
- Use weatherproof connectors at every joint
- Re-check rack and plate bolts after the first few trail runs
- Aim the lights to avoid dazzling other drivers
Specifications
| Brand | Go Rhino |
|---|---|
| Part number | 5912232T |
| UPC | 887753147264 |
| Material | Steel |
| Drilling required | No |
| Lights held | Two 3″ cube lights |
| Bar | 20″ bar |
| Fitment | Universal Fit |
Vehicle fitment
This plate is designed for the SRM100 rack, so the rack model is the deciding factor. Confirm your rack model and your vehicle’s year, model and trim before mounting it to your roof.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan the light wiring before mounting. Use a fuse and relay for the cube lights, and check local rules on auxiliary lights for road use.









