Overview
The Flowmaster Exhaust 15401 is a weld-on carbon fiber exhaust tip sized for 3.00 inch O.D. tubing. It is universal fit, so the tubing diameter on your exhaust decides whether it suits your system rather than a make, model or year. The angle cut, rolled edge outer shell is carbon fiber over a 304S stainless steel inner core.
The 15401 has a 4.00 inch O.D. outlet and measures 5.25 inches overall. The Flowmaster logo is featured on the tip, and the specifications below list every dimension and material given for it.
Key features
- Real carbon fiber outer shell with a rolled, angle cut edge
- 304S stainless steel inner core for durability
- Weld-on design for 3.00 inch O.D. tubing
- 4.00 inch O.D. outlet
- 5.25 inches overall length
- Flowmaster logo featured on the tip
Welding and finish care
Carbon fiber tips are cosmetic at the outlet, so the structural job falls to the metal joint where the tip meets the pipe. Before welding, clean the pipe end and square the cut so the tip seats evenly. Heat from welding can discolor or damage the carbon fiber shell, so mask the finish and keep the weld on the steel areas away from it.
Between drives, wipe the tip with mild soap and water rather than abrasive pads, which can scratch the surface. Check the weld for cracks or pinholes after the first few runs, since vibration and heat cycles are what loosen a weld over time. Tips mounted near the bumper or rear valance should also be checked for rubbing.
Specifications
| Brand | Flowmaster Exhaust |
|---|---|
| Part number | FLW15401 |
| Shape | Round |
| Outlet O.D. | 4.00 inch, angle cut, rolled edge |
| Tubing diameter | 3.00 inch O.D. |
| Overall length | 5.25 inches |
| Finish | Carbon fiber |
| Material | Carbon fiber outer shell, 304S stainless steel inner core |
| Fitment | Universal fit |
Vehicle fitment
It is universal fit and sized by tubing diameter, so match the 3.00 inch O.D. tubing on your exhaust before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a weld-on tip, so it has to be welded to 3.00 inch O.D. tubing, not clamped. Welding exhaust should be done by someone experienced with exhaust work, and the tip should be fully secured before the system is run.
What’s included
One weld-on carbon fiber exhaust tip with the Flowmaster logo.
Not included: the exhaust tubing and welding needed to attach the tip.










