Overview
The Fab Fours FFIDR19-D4251-1 is a black steel Vengeance Series front bumper for the 2019–2026 Ram 1500. It weighs 75 lb and is a lightweight option for the front of the truck.
The bumper has a center cutout for a 20-inch LED light bar and mounting options on each side for two Rigid Industries Dually lights. Its high, tight fit has lower cutouts for airflow. It is a full-width bumper and is not winch mount compatible.
The 75 lb weight is the figure Fab Fours gives for this bumper. Owners comparing bumpers should use the same measure, since makers may list weights with or without mounts and lights.
The center cutout is sized for a 20-inch LED light bar, so a light bar of that size is the intended setup.
The side mounts take two Rigid Industries Dually lights on each side, so those lights are part of the planned setup.
Key features
- Center cutout for a 20-inch LED light bar
- Mounting options on each side for two Rigid Industries Dually lights
- Light mounts included
- High, tight fit with lower cutouts for airflow
- Weighs 75 lb
- Available with no guard or a pre-runner guard
Front-end weight and suspension
A steel bumper with lights and mounts adds weight ahead of the front axle, and that weight affects steering feel, braking distance and how the suspension settles. Heavier front ends can also load the bump stops and shocks sooner on rough terrain. Think about the total weight of the bumper, lights and any winch before you add more equipment.
After installation, check the alignment and look at the front shocks and bushings for wear. Tire pressure and load ratings also matter more with a heavier front end. Over time, keep an eye on the bolts that hold the bumper to the frame, since added weight can loosen them on rough roads.
- Recheck the alignment after installation
- Inspect shocks and bump stops for wear
- Confirm tire load ratings suit the setup
- Tighten frame mount bolts after rough roads
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FFIDR19-D4251-1 |
| Finish | Black |
| Material | Steel |
| Weight | 75 lb |
| Width | Full |
| Position | Front |
| Winch mount | Not compatible |
| Light mounts | Included |
| D-ring mounts | Not included |
| Fitment | 2019–2026 Ram 1500 |
Vehicle fitment
It is a front bumper for the 2019–2026 Ram 1500 pickup.
The list does not include the Ram 2500 or Ram 3500, or Ram 1500 model years before 2019. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The side mounting options are for two Rigid Industries Dually lights. Route the light wiring through a fused relay and check local rules on auxiliary lights.
What’s included
Front bumper with light mounts.
Not included: D-ring mounts are not included. The Rigid Industries lights are sold separately.










