Overview
The Fab Fours FFIJK07-B1952-1 is a black steel stubby front bumper with a guard, built for the 2007–2018 Jeep Wrangler JK. The four-door 2018–2019 Wrangler JL also fits. Its ultra-narrow design gives maximum tire clearance and is no wider than the grille.
The bumper is made of 3/16 inch steel, fully welded inside and out, with tapered edges and the Fab Fours knife edge design. It is winch ready with the winch plate included, has integrated D-rings and tow hooks, and has fog light housings that take 3×3 pod lights or factory fogs. The hoop is included.
Key features
- Ultra-narrow stubby design for tire clearance
- Winch ready, with the winch plate included
- Integrated D-rings and tow hooks
- Integrated fog light housings for 3×3 pod lights or factory fogs
- Hoop included, no stinger
- 3/16 inch steel, fully welded
- Tapered edges and knife edge design
Guard and fog light setup
A guard on a stubby bumper protects the area around the grille and headlights, and it is the part most likely to take a hit in brush or on rock. A guard also changes the front weight and how the bumper sits, so check the mounting bolts after the first few uses on rough ground.
Fog light housings work best when the lights are aimed low and level with the road. Set the aim on level ground before trail use, and recheck it after the bumper has been struck or the lights have been removed. Route any pod or fog light wiring through a fused relay and use a switch that is easy to reach.
The hoop helps protect the front, but it is not a substitute for proper recovery points. Inspect D-rings and tow hooks for bends after recovery work, and keep winch plate bolts snug. Steel bumpers can rust at welds, so touch up chips quickly and keep the finish intact.
- Aim fog lights low and level on flat ground
- Check guard and plate bolts after rough trails
- Inspect D-rings and tow hooks after recovery
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FFIJK07-B1952-1 |
| Finish | Black |
| Material | Steel, 3/16 inch |
| Position | Front |
| Width | Stubby |
| Winch mount | Compatible, winch plate included |
| Light mounts | Included |
| Hoop | Included |
| Stinger | Not included |
| Fitment | 2007–2018 Jeep Wrangler JK; 2018–2019 Jeep Wrangler JL four-door |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler JK in two-door and four-door bodies, and the four-door 2018–2019 Wrangler JL.
The Wrangler JL entry is limited to four-door 2018–2019 models, so two-door JL models and later JL years are not shown. The Gladiator JT and earlier generations are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pod or fog light wiring should run through a fused relay, and local rules on auxiliary lights apply before road use.
What’s included
Front stubby bumper with guard, hoop, winch plate and integrated fog light housings.
Not included: Pod lights and fog lights are sold separately.











