Overview
The Fab Fours Full Size Rear Bumper in bare steel, part number FS08-W1350-B, is a rear bumper for the 1999–2015 Ford F-250 Super Duty and F-350 Super Duty. It integrates the existing receiver hitch and adds D-ring recovery points.
The steel is 3/16-inch formed material, with integrated steps on either side of the tailgate and 1/4-inch keyed and gusseted mounts. Without a coating, it leaves finishing to the owner.
Key features
- Bare steel finish
- Integrated steps on either side of the tailgate
- 3/16-inch formed steel construction
- 3/4-inch D-ring recovery points, D-ring mounts included
- 1/4-inch keyed and gusseted mounts
- Retains the OEM receiver hitch and wiring locations
Before you buy
A bare steel rear bumper is a structural part that takes impacts, carries recovery loads and often supports a hitch, so its condition matters on the trail. Bare steel is more exposed than a finished part. Surface rust can start at welds and mounting holes once the metal sees moisture, so prepare the surface and apply a coating before the bumper goes into service. Check the finish after the first trail runs for chips, especially along the lower edge where rocks and mud hit.
Because the bumper mounts to the frame at keyed and gusseted points, bolts should be checked periodically for tightness. Loosening can show up as rattling or a shifted tailgate gap. Shackles used on the D-ring recovery points should be rated for the load and kept clear of the tailgate when the truck is in use. Anyone adding a trailer or accessory to the hitch should confirm the bumper and wiring leave enough room to operate safely.
- Check the coating for chips after the first trail runs
- Re-check D-ring hardware before each recovery
- Keep the hitch receiver free of mud and debris
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FS08-W1350-B |
| UPC | 5810101343 |
| Product type | Full size rear bumper |
| Finish | Bare steel |
| Steel construction | 3/16 in formed steel |
| Recovery points | 3/4 in D-rings, included |
| Mounts | 1/4 in keyed and gusseted |
| Position | Rear |
| Fit type | Direct fit |
| Tire carrier | None |
| Origin | Made in the USA |
Vehicle fitment
Fab Fours lists part FS08-W1350-B for the 1999–2015 Ford F-250 Super Duty and the 1999–2015 Ford F-350 Super Duty.
Super Duty trucks from 2016 onward and the F-150 pickups are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bare steel should be coated before it is mounted. The original hitch and wiring locations are retained, so no relocation is described.
What’s included
One bare steel rear bumper, with D-ring mounts and tailgate steps.
Not included: Shackles and any paint or coating.
















