Overview
The DV8 Offroad A pillar pod LED light mount, part number DV8LBJL-02, is a steel bracket that bolts directly to factory mounting points and holds four DV8 POD LED lights (PartNo B3CE20W5W). The manufacturer fitment list includes the 2020-2026 Jeep Gladiator and the 2018-2019 Jeep Wrangler (JL).
The brackets are laser cut and CNC bent from 3/16 inch steel, then finished with a textured powder coat. DV8 Offroad describes them as easy to install and amazingly sturdy, and because they use existing mounting points, no drilling is needed.
Key features
- Bolts directly to factory mounting points
- Holds four DV8 POD LED lights (PartNo B3CE20W5W)
- Laser cut and CNC bent steel construction
- Textured powder coat finish
- No drilling required
Before you mount pillar pods
Pillar pods throw light forward and to the side, which is useful on trails where the front corners are hard to see. Pillar placement also keeps lights above the hood line, away from mud and stones kicked up by the tires. Position matters, so sit in the driver’s seat and check how the lights line up with the windshield and your sightline before bolting anything down.
Wiring a pillar setup is a separate job from mounting it. Route cable along existing trim and away from airbag wiring, and keep the harness in a loom where it crosses the door opening. Use a fused relay so the lights draw from a protected circuit. After a few weeks of trail use, check fasteners and the powder coat for chips, since stone strikes are the usual cause of finish damage on pillar mounts.
- Check the sightline from the driver’s seat
- Keep harness clear of airbag wiring
- Inspect the powder coat after rocky trail runs
Specifications
| Brand | DV8 Offroad |
|---|---|
| Part number | DV8LBJL-02 |
| Mount type | A pillar light pod mount |
| Material | Steel, 3/16 inch |
| Finish | Textured powder coat |
| Light capacity | Four DV8 POD LED lights (PartNo B3CE20W5W) |
| Installation | Bolts to factory mounting points, no drilling required |
| Fitment | Direct fit, per manufacturer |
Vehicle fitment
The manufacturer fitment list includes the 2020-2026 Jeep Gladiator in Launch Edition, Overland, Rubicon, Sport and Sport S trims, and the 2018-2019 Jeep Wrangler (JL) in two-door and four-door Rubicon, Sport, Sport S, Moab and Sahara trims.
The Wrangler entries stop at model year 2019, so 2020-2026 Wrangler JL is not on the manufacturer list. Jeep Wrangler JK and earlier generations are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the mount uses factory mounting points, no drilling or cutting is needed. Wire the DV8 pods through a fused relay, and confirm local road-use rules for auxiliary lights before driving with them lit on public roads.
What’s included
The kit is the bracket itself. Four DV8 POD LED lights (PartNo B3CE20W5W) are needed to fill it, so confirm the lights and any wiring you need before installation.
Not included: Confirm the lights are on hand before installing, and check the package contents against your installation before starting.












