Overview
The Curt QuickPin 2-inch no-latch trailer coupler, part number CRT25470, connects a trailer to the hitch ball without a latch. To couple it, drop the trailer tongue onto the ball and slide in the pin. Curt designed the QuickPin coupler to make trailer hookup as simple as possible, since traditional latches can be hard to close and can wear out, corrode, jam and break.
The coupler is fully tested to SAE J684 specifications and is rated for 3,500 lbs gross trailer weight. It accepts a standard 2-inch diameter trailer ball and mounts onto a 2-inch wide trailer tongue beam. It needs no adjusting or tightening and is compatible with most existing coupler mounting hole configurations.
Key features
- No latch: drop the tongue onto the ball and slide in the pin
- No adjusting or tightening required
- Tested to the SAE J684 standard
- Rated for 3,500 lbs gross trailer weight
- Accepts a standard 2-inch diameter trailer ball
- Mounts onto a 2-inch wide trailer tongue beam
- Compatible with most existing coupler mounting hole configurations
- Includes a 1/2-inch pin for securing the ball mount connection
Before you hitch up
A no-latch coupler relies on the trailer tongue sitting fully on the hitch ball and the pin being fully seated. Before each trip, confirm the ball is the correct size, that the pin is in place and that the tongue is seated on the ball rather than resting above it. These checks take only a moment.
Safety chains, the breakaway cable and the trailer lights should be checked along with the coupler. Make sure the chains are crossed under the tongue and attached to the tow vehicle, and test the trailer lights before leaving. Inspect the coupler, the tongue beam and the mounting hardware periodically for cracks, bends or looseness, and replace worn parts before they fail.
- Confirm ball size matches the coupler
- Check that the pin is fully seated
- Cross safety chains under the tongue
- Inspect mounting hardware for looseness
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT25470 |
| Model | QuickPin |
| Coupler type | No-latch |
| Gross trailer weight rating | 3,500 lbs |
| Ball size | 2-inch diameter, standard |
| Tongue beam width | 2-inch wide |
| Testing | SAE J684 specifications |
| Included pin | 1/2-inch |
Vehicle fitment
Fitment does not apply to this coupler, since it is a trailer part rather than a vehicle part. Match the ball size and tongue width to your trailer before ordering.
It accepts a 2-inch ball and a 2-inch wide tongue beam. Check the hole pattern on your trailer before mounting, since compatibility depends on it.
Installation notes
Use the 1/2-inch pin supplied for hookup. This pin is needed for hookup and should not be swapped for a different hitch pin. Mounting hardware for the trailer frame must be bought separately, so have it ready before fitting the coupler.
What’s included
The QuickPin trailer coupler and a 1/2-inch pin for securing the ball mount connection.
Not included: mounting hardware for attaching the coupler to the trailer frame, which must be obtained separately.









