Overview
The Curt Manufacturing 13067, part number CRT13067, is a Class III/IV rear trailer hitch with a 2.5-inch receiver. It fits the 2007–2014 Ford Edge and the 2007–2015 Lincoln MKX. It installs with no drilling and uses a new round tubular design.
Curt positions this Class III design for towing needs above 4,000 pounds gross trailer weight and below 10,000 pounds. It is finished in gloss black powder coat and does not fit with a roll pan.
Key features
- Round tubular Class III design
- No-drill installation
- Covers towing needs above 4,000 pounds and below 10,000 pounds gross trailer weight
- Gloss black powder coat finish
- Rear-mounted; does not fit with a roll pan
Towing range and setup
A Class III hitch sits in the middle of the range for mid-sized towing, so the trailer’s weight and tongue weight decide whether it is a good match. Heavier trailers push more load through the receiver and frame, and a load that sits too far back or too light can cause sway. Weigh the loaded trailer when you can and keep tongue weight within your vehicle’s limits.
Hitch height matters too. A trailer that sits level behaves better than one that tips up or down, and a ball mount with the right drop or rise makes that possible. Check the lights and wiring each time you hook up.
- Weigh the loaded trailer before towing
- Confirm tongue weight stays within limits
- Check trailer level after each hookup
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT13067 |
| Front or rear | Rear |
| Receiver size | 2.5 inches x 2.5 inches |
| Weight class | Class III/IV |
| Gross trailer weight range | More than 4,000 pounds to less than 10,000 pounds |
| Installation | No drilling |
| Finish | Gloss black powder coat |
| Roll pan | Does not fit with roll pan |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2014 Ford Edge in the Limited, SE, SEL and Sport trims, and the 2007–2015 Lincoln MKX in the Base trim.
Ford and Lincoln models, and model years outside those ranges, are not covered by this fit. Confirm the receiver size against your ball mount, since the receiver measures 2.5 inches x 2.5 inches. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
This design is installed without drilling. Compare the receiver size with your ball mount before fitting.
What’s included
A Class III/IV round tubular hitch in gloss black powder coat. Check the included parts against your installation before starting.
Not included: ball mounts, hitch accessories or trailers, which you select separately.









