Overview
The Crown Automotive 52007048 is a front emergency brake cable for the 1991–1995 Jeep Wrangler (YJ). It runs from the parking brake pedal to the equalizer, the point where the cable splits toward the rear brakes.
The part is the front section of the parking brake system, so rear cables are bought separately.
Key features
- Front emergency brake cable
- Runs from the pedal to the equalizer
- Direct fit for the 1991–1995 Wrangler (YJ)
- Replacement cable from Crown Automotive
Front cable role
The front emergency brake cable links the parking brake pedal inside the cabin with the equalizer under the vehicle. When the pedal is set, the cable pulls the equalizer, which tensions the rear cables running to the drum brakes. Because the front cable carries the full pull from the pedal, it is the part that most often stretches or frays with age.
Look for kinks, rust near the sheath ends, and a pedal that travels farther than it used to before the brakes hold. Rear cables are often inspected at the same time, since a worn rear cable can leave the equalizer pulling unevenly. Lubricating the pivot points at the pedal and equalizer during a brake service helps the system move freely.
- Check the sheath for cracks and rust
- Test pedal travel and hold on a slope
- Inspect the equalizer for binding
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52007048 |
| UPC | 848399013917 |
| Part type | Emergency brake cable |
| Position | Front |
| Route | Pedal to equalizer |
| Fit type | Direct fit |
Vehicle fitment
It is a direct fit for the 1991–1995 Jeep Wrangler (YJ).
Earlier YJ years and the TJ are not covered. Check your Wrangler’s year and trim against this cable before ordering.












