Overview
The Bushwacker Ultimate BedRail Cap, part number 29509, is a truck bed rail cover made from Dura-Flex 2000 TPO for Ford Ranger and Mazda B4000 pickups. It protects the top edge of the bed rail from dents, dings and scratches and can conceal minor damage. It is a direct fit for those trucks.
Bushwacker manufactures the cap in the USA from the same Dura-Flex 2000 TPO used for its Trail Armor line for Jeeps. The cap is extra thick to absorb impact and resist warping, and its 100% UV protection helps prevent chalking. It is engineered for the Ford or Mazda truck it is sold for, with close tolerances and smoothly finished edges. The finish is OEM matte black with a DiamondBack textured look.
Key features
- Dura-Flex 2000 TPO construction with 100% UV protection
- Extra thick to absorb impact and resist warping
- Made in the USA
- OEM matte black finish with DiamondBack textured surface
- Installs with 3M adhesive and a screw-clip system, no drilling
- Smoothly finished edges and close tolerances for a snug fit
- Covered by a Limited Lifetime Warranty
Preparing the rail for a cap
A bed rail cap sits on the top edge of the bed, where dents and scuffs tend to start when tools, coolers and tailgates bump the rail. Its main job is cosmetic and protective: it adds a layer between the metal or plastic underneath and daily wear. On a work truck the rail sees a lot of contact, so the cap’s surface matters as much as its fit. A textured surface like this one can hide light scuffs better than a smooth finish, though it will still show deep gouges.
Adhesive-mounted caps depend on a clean, dry rail. Wipe away dust, road grime and any wax before setting the cap, and avoid applying it in cold or damp conditions. After installation, press along the full length and check the screw clips for even seating. Recheck the seal along the edges after a few weeks of driving, especially if the truck sees rain or car washes often. If an edge lifts, clean the area and address it before the adhesive weakens further.
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 29509 |
| UPC | 90689113436 |
| Material | Plastic (Dura-Flex 2000 TPO) |
| Finish | OEM matte black with DiamondBack textured finish |
| Fitment type | Direct Fit |
| Mounting | 3M adhesive and screw-clip system, no drilling |
| Warranty | Limited Lifetime Warranty |
| Country of manufacture | USA |
Vehicle fitment
Part 29509 is a direct fit for the following vehicles:
- 1993–2011 Ford Ranger (EV, Edge, FX4, Sport, Tremor, XL, XL Sport, XLT)
- 1994–1999, 2003–2009 Mazda B4000 (Base, DS, LE, SE)
Model years between the ranges above are not covered, and Ford Ranger years after 2011 are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mounting uses 3M adhesive together with a screw-clip system, and Bushwacker states no drilling is needed. Since the adhesive does much of the work, confirm the cap is fully seated along the rail before the truck is used to haul loads.
What’s included
The Ultimate BedRail Cap comes with its 3M adhesive and screw-clip mounting system. Check the package contents against your installation before starting.









