Overview
The BedRug XLT Mat, part number XLTBMT09CCS, is a custom-fit truck bed mat made from ultra-tough 100% polypropylene. BedRug makes it to fit the specific make and model of each truck, filling in the ribs and contours of the bed to create a smooth, void-free loading surface. It is designed for trucks that have an existing spray-in liner or no bed liner.
The mat gives the bed a flat, slip and skid resistant work surface over a 3/4-inch padded under layer. That padding adds dent and impact resistance and cushions your knees while you crawl around in the bed. An integrated tailgate gap guard hinge joins the bed piece to the tailgate piece and covers the gap between them, which keeps debris from building up there.
The mat sheds water, so it runs off the surface and out the factory drain holes. The polypropylene is fade and UV resistant. It resists mold and mildew, and bleach, battery acid, oil and gas wash off the surface.
Key features
- Ultra-tough 100% polypropylene top layer with a flat, slip and skid resistant surface.
- 3/4-inch padded under layer for dent and impact resistance and knee cushioning.
- Integrated tailgate gap guard hinge that covers the gap between bed and tailgate.
- Custom fit to each truck’s make and model, filling ribs and contours.
- Will not absorb water; water drains out the factory drain holes and dries in as little as 20 minutes.
- Bleach, battery acid, oil and gas wash right off, and the polypropylene is fade and UV resistant.
- Installs in minutes with hook and loop fasteners, with no sanding, prepping or drilling holes.
Care and cleaning
Polypropylene surfaces handle everyday truck use well, but they still benefit from routine cleaning. Sand and road grit can work underneath any bed mat and wear the bed finish, so lift the edges occasionally and clear debris from the bed floor. A stiff brush and mild soap handle most dirt on the top surface.
Check the tailgate gap guard hinge after rough trips. Look for loose debris, bent edges or a gap that has opened, and clear it out before it builds up. Where the mat meets the wheel wells, make sure the edges still sit flat and that no bed liner has lifted under the foam.
Water drains to the factory holes, so keep those openings clear of mud and leaves. A plugged drain can hold water against the bed, which is where rust tends to start on bare steel. If the foam underlayer looks compressed or crushed, the mat is past its useful cushioning and should be replaced.
- Rinse grit from under the mat every few months
- Clear the factory drain holes after wet trips
- Replace the mat if the foam underlayer is crushed
Specifications
| Brand | BedRug |
|---|---|
| Part number | XLTBMT09CCS |
| UPC | 870558005907 |
| Top layer material | Ultra-tough 100% polypropylene |
| Under layer | 3/4-inch padded foam |
| Surface | Flat, slip and skid resistant |
| Fit | Custom fit to make and model, fills ribs and contours |
| Fastening | Hook and loop fasteners |
| Tailgate | Integrated gap guard hinge |
| Use | Designed for exterior use |
Vehicle fitment
It is made to fit the specific make and model of each truck it is sized for, so the bed it fits depends on your vehicle.
Confirm your vehicle’s year, model and trim before ordering. If you are unsure whether your truck has a spray-in liner, check your bed type before ordering.
Installation notes
The mat installs in minutes with hook and loop fasteners and needs no sanding, prepping or drilling into the bed. Because it is made to a specific make and model, confirm it matches your truck before you begin.
What’s included
The XLT Mat truck bed mat, part number XLTBMT09CCS, with the hook and loop fasteners used to install it.





